[PATCH v7 1/6] mtd: nand: omap: add field to indicate current ecc-scheme in 'struct omap_nand_info'

[Pekon Gupta <pekon@ti.com>]

Information of currently selected ECC scheme 'enum omap_ecc ecc_opt' should
available outside platform-data, so that single nand_chip->ecc callback can
support multiple ecc-scheme configurations.

Signed-off-by: Pekon Gupta <pekon@ti.com>
---
 drivers/mtd/nand/omap2.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/nand/omap2.c b/drivers/mtd/nand/omap2.c
index 768e7cf..8fb64d5 100644
--- a/drivers/mtd/nand/omap2.c
+++ b/drivers/mtd/nand/omap2.c
@@ -160,6 +160,7 @@ struct omap_nand_info {
 	int				gpmc_cs;
 	unsigned long			phys_base;
 	unsigned long			mem_size;
+	enum omap_ecc			ecc_opt;
 	struct completion		comp;
 	struct dma_chan			*dma;
 	int				gpmc_irq_fifo;
@@ -1657,6 +1658,7 @@ static int omap_nand_probe(struct platform_device *pdev)
 	info->gpmc_cs		= pdata->cs;
 	info->reg		= pdata->reg;
 	info->of_node		= pdata->of_node;
+	info->ecc_opt		= pdata->ecc_opt;
 	mtd			= &info->mtd;
 	mtd->priv		= &info->nand;
 	mtd->name		= dev_name(&pdev->dev);
@@ -1812,7 +1814,7 @@ static int omap_nand_probe(struct platform_device *pdev)
 	/* populate MTD interface based on ECC scheme */
 	nand_chip->ecc.layout	= &omap_oobinfo;
 	ecclayout		= &omap_oobinfo;
-	switch (pdata->ecc_opt) {
+	switch (info->ecc_opt) {
 	case OMAP_ECC_HAM1_CODE_HW:
 		pr_info("nand: using OMAP_ECC_HAM1_CODE_HW\n");
 		nand_chip->ecc.mode             = NAND_ECC_HW;
-- 
1.8.1