[PATCH 6/7] mtd: ptx1kbf: Bindings for Juniper's PTX1K Boot FPGA

[Pantelis Antoniou <pantelis.antoniou@konsulko.com>]

From: Georgi Vlaev <gvlaev@juniper.net>

Add binding document for Junipers Flash IP block present
in the PTX1K Boot FPGA on PTX series of routers.

Signed-off-by: Georgi Vlaev <gvlaev@juniper.net>
[Ported from Juniper kernel]
Signed-off-by: Pantelis Antoniou <pantelis.antoniou@konsulko.com>
---
 .../devicetree/bindings/mtd/ptx1kbf-mtd.txt        | 23 ++++++++++++++++++++++
 1 file changed, 23 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/mtd/ptx1kbf-mtd.txt

diff --git a/Documentation/devicetree/bindings/mtd/ptx1kbf-mtd.txt b/Documentation/devicetree/bindings/mtd/ptx1kbf-mtd.txt
new file mode 100644
index 0000000..4e25060
--- /dev/null
+++ b/Documentation/devicetree/bindings/mtd/ptx1kbf-mtd.txt
@@ -0,0 +1,23 @@
+Flash device on a PTX1K Boot FPGA
+
+These flash chips are found in the PTX series of Juniper routers.
+
+Required properties:
+- compatible : must be "jnx,flash-sam"
+
+Optional properties:
+- reg : memory address for the flash chip, note that this is not
+required since usually the device is a subdevice of the SAM MFD
+driver which fills in the register fields.
+
+For the rest of the properties, see mtd-physmap.txt.
+
+The device tree may optionally contain sub-nodes describing partitions of the
+address space. See partition.txt for more detail.
+
+Example:
+
+ptx1kbf_mtd {
+	compatible = "jnx,ptx1kbf-mtd";
+	/* usually the whole flash is used */
+};
-- 
1.9.1