Re: [PATCH v5 2/5] omap3: nand: prefetch in irq mode support

[Tony Lindgren <tony@atomide.com>]

* Sukumar Ghorai <s-ghorai@ti.com> [100927 06:30]:
>  This patch enable prefetch-irq mode for NAND.

> --- a/drivers/mtd/nand/Kconfig
> +++ b/drivers/mtd/nand/Kconfig
> @@ -112,6 +112,9 @@ config MTD_NAND_OMAP_PREFETCH
>  	help
>  	 The NAND device can be accessed for Read/Write using GPMC PREFETCH engine
>  	 to improve the performance.
> +	 GPMC PREFETCH can be configured eigther in MPU interrupt mode or in DMA
> +	 interrupt mode. If not selected any of them prefetch will be used in
> +	 polling mode.
>  
>  config MTD_NAND_OMAP_PREFETCH_DMA
>  	depends on MTD_NAND_OMAP_PREFETCH
> @@ -120,7 +123,16 @@ config MTD_NAND_OMAP_PREFETCH_DMA
>  	help
>  	 The GPMC PREFETCH engine can be configured eigther in MPU interrupt mode
>  	 or in DMA interrupt mode.
> -	 Say y for DMA mode or MPU mode will be used
> +	 Say y for DMA mode
> +
> +config MTD_NAND_OMAP_PREFETCH_IRQ
> +	depends on MTD_NAND_OMAP_PREFETCH && !MTD_NAND_OMAP_PREFETCH_DMA
> +	bool "IRQ mode"
> +	default n
> +	help
> +	 The GPMC PREFETCH engine can be configured eigther in MPU interrupt mode
> +	 or in DMA interrupt mode.
> +	 Say y for IRQ mode
>  
>  config MTD_NAND_IDS
>  	tristate

The configuration to use the prefetch IRQ should be passed in the platform_data
from the board-*.c files. What if you want to to boot a distro kernel on
omap2, 3 and 4 and only some of the boards can use the prefetch interrupt?

Tony