Re: [PATCH] mtd/m25p80: add device tree probe support

Marek Vasut
2012-06-26T11:47:01Z

Dear Shawn Guo,

> On Mon, Jun 25, 2012 at 06:50:10PM +0200, Marek Vasut wrote:
> > 116 ssp2: ssp@80014000 {
> > 117 #address-cells = <1>;
> > 118 #size-cells = <0>;
> > 119 compatible = "fsl,imx28-spi";
> > 120 pinctrl-names = "default";
> > 121 pinctrl-0 = <&spi2_pins_a>;
> > 122 status = "okay";
> > 123
> > 124 flash: m25p80@0 {
> > 125 #address-cells = <1>;
> > 126 #size-cells = <1>;
> > 127 compatible = "m25p80";
> > 128 spi-max-frequency =
> > <25000000>; 129 reg = <0>;
> > 130 };
> > 131 };
> >
> > I use this + my SPI patches I submitted recently.
>
> I do not have the flash on my imx28-evk board, but I just tested on
> imx6q-sabrelite, and yes, it can be probed without the patch. I'm
> fine then.

Good, let's discard this patch and close this issue :-)

Best regards,
Marek Vasut