From: Ezequiel Garcia <ezequiel.garcia@free-electrons.com>
To: Brian Norris <computersforpeace@gmail.com>
Cc: Thomas Petazzoni <thomas.petazzoni@free-electrons.com>,
Lior Amsalem <alior@marvell.com>,
Jason Cooper <jason@lakedaemon.net>,
Tawfik Bayouk <tawfik@marvell.com>,
Artem Bityutskiy <dedekind1@gmail.com>,
Daniel Mack <zonque@gmail.com>,
linux-mtd@lists.infradead.org,
Gregory Clement <gregory.clement@free-electrons.com>,
Willy Tarreau <w@1wt.eu>
Subject: Re: [PATCH 00/21] Armada 370/XP NAND support
Date: Wed, 25 Sep 2013 07:41:00 -0300 [thread overview]
Message-ID: <20130925104059.GB2418@localhost> (raw)
In-Reply-To: <52428241.6030907@gmail.com>
On Tue, Sep 24, 2013 at 11:27:13PM -0700, Brian Norris wrote:
> > I'm preparing a new v2 which some (very minor) improvements, mainly to
> > add support for timings configuration.
>
> I believe Daniel reported a bug w/ PIO vs. DMA. I presume this will be
> in v2? If those modifications aren't too big, then I can look at the
> current series.
>
Yes, the fix will be in v2, but it's (apparently) going to be a very
minor fix.
The current patchset contains almost all the juicy stuff.
--
Ezequiel García, Free Electrons
Embedded Linux, Kernel and Android Engineering
http://free-electrons.com
next prev parent reply other threads:[~2013-09-25 10:41 UTC|newest]
Thread overview: 45+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-09-19 16:01 [PATCH 00/21] Armada 370/XP NAND support Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 01/21] mtd: nand: pxa3xx: Allocate data buffer on detected flash size Ezequiel Garcia
2013-09-26 20:10 ` Brian Norris
2013-09-30 12:37 ` Ezequiel Garcia
2013-10-02 21:14 ` Brian Norris
2013-09-19 16:01 ` [PATCH 02/21] mtd: nand: pxa3xx: Disable OOB on arbitrary length commands Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 03/21] mtd: nand: pxa3xx: Use a completion to signal device ready Ezequiel Garcia
2013-10-02 21:56 ` Brian Norris
2013-10-04 18:54 ` Ezequiel Garcia
2013-10-16 20:23 ` Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 04/21] mtd: nand: pxa3xx: Add bad block handling Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 05/21] mtd: nand: pxa3xx: Add driver-specific ECC BCH support Ezequiel Garcia
2013-10-03 0:24 ` Brian Norris
2013-10-04 19:49 ` Ezequiel Garcia
2013-10-05 0:27 ` Brian Norris
2013-10-17 22:27 ` Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 06/21] mtd: nand: pxa3xx: Configure detected pages-per-block Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 07/21] mtd: nand: pxa3xx: Clear cmd buffer #3 (NDCB3) on command start Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 08/21] mtd: nand: pxa3xx: Make config menu show supported platforms Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 09/21] mtd: nand: pxa3xx: Split FIFO size from to-be-read FIFO count Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 10/21] mtd: nand: pxa3xx: Replace host->page_size by mtd->writesize Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 11/21] mtd: nand: pxa3xx: Add helper function to set page address Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 12/21] mtd: nand: pxa3xx: Remove READ0 switch/case falltrough Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 13/21] mtd: nand: pxa3xx: Split prepare_command_pool() in two stages Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 14/21] mtd: nand: pxa3xx: Move the data buffer clean to prepare_start_command() Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 15/21] mtd: nand: pxa3xx: Add a read/write buffers markers Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 16/21] mtd: nand: pxa3xx: Introduce multiple page I/O support Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 17/21] mtd: nand: pxa3xx: Add multiple chunk write support Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 18/21] ARM: mvebu: Add a fixed 0Hz clock to represent NAND clock Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 19/21] ARM: mvebu: Add support for NAND controller in Armada 370/XP Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 20/21] ARM: mvebu: Enable NAND controller in Armada XP GP board Ezequiel Garcia
2013-09-19 16:01 ` [PATCH 21/21] ARM: mvebu: Enable NAND controller in Armada 370 Mirabox Ezequiel Garcia
2013-09-19 17:47 ` [PATCH 00/21] Armada 370/XP NAND support Daniel Mack
2013-09-19 18:34 ` Ezequiel Garcia
2013-09-19 21:17 ` Ezequiel Garcia
2013-09-19 21:26 ` Daniel Mack
2013-09-24 18:59 ` Ezequiel Garcia
2013-09-25 6:27 ` Brian Norris
2013-09-25 10:41 ` Ezequiel Garcia [this message]
2013-09-26 19:56 ` Brian Norris
2013-09-30 12:24 ` Ezequiel Garcia
2013-10-03 0:02 ` Brian Norris
2013-10-04 19:42 ` Ezequiel Garcia
2013-10-05 0:06 ` Brian Norris
2013-10-16 23:29 ` Ezequiel Garcia
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20130925104059.GB2418@localhost \
--to=ezequiel.garcia@free-electrons.com \
--cc=alior@marvell.com \
--cc=computersforpeace@gmail.com \
--cc=dedekind1@gmail.com \
--cc=gregory.clement@free-electrons.com \
--cc=jason@lakedaemon.net \
--cc=linux-mtd@lists.infradead.org \
--cc=tawfik@marvell.com \
--cc=thomas.petazzoni@free-electrons.com \
--cc=w@1wt.eu \
--cc=zonque@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).