From mboxrd@z Thu Jan 1 00:00:00 1970 Received: from mail-out.m-online.net ([212.18.0.9]) by bombadil.infradead.org with esmtps (Exim 4.80.1 #2 (Red Hat Linux)) id 1aIzM1-0007yi-QT for linux-mtd@lists.infradead.org; Tue, 12 Jan 2016 13:51:23 +0000 From: Marek Vasut To: Vignesh R Subject: Re: [PATCH V10 2/2] mtd: spi-nor: Add driver for Cadence Quad SPI Flash Controller. Date: Tue, 12 Jan 2016 14:49:49 +0100 Cc: Dinh Nguyen , "linux-mtd@lists.infradead.org" , Graham Moore , Alan Tull , Brian Norris , David Woodhouse , Yves Vandervennet , "devicetree@vger.kernel.org" References: <1452486886-8049-1-git-send-email-marex@denx.de> <5693D3B4.2090304@opensource.altera.com> <569483DE.4070901@ti.com> In-Reply-To: <569483DE.4070901@ti.com> MIME-Version: 1.0 Content-Type: Text/Plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Message-Id: <201601121449.49266.marex@denx.de> List-Id: Linux MTD discussion mailing list List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , On Tuesday, January 12, 2016 at 05:41:02 AM, Vignesh R wrote: > On 01/11/2016 09:39 PM, Dinh Nguyen wrote: > > On 01/10/2016 10:34 PM, Marek Vasut wrote: > >> From: Graham Moore > >> > >> Add support for the Cadence QSPI controller. This controller is > >> present in the Altera SoCFPGA SoCs and this driver has been tested > >> on the Cyclone V SoC. > > [...] > > >> diff --git a/drivers/mtd/spi-nor/Kconfig b/drivers/mtd/spi-nor/Kconfig > >> index 43bafde..7e29050 100644 > >> --- a/drivers/mtd/spi-nor/Kconfig > >> +++ b/drivers/mtd/spi-nor/Kconfig > >> @@ -50,4 +50,15 @@ config SPI_NXP_SPIFI > >> > >> Flash. Enable this option if you have a device with a SPIFI > >> controller and want to access the Flash as a mtd device. > >> > >> +config SPI_CADENCE_QUADSPI > >> + tristate "Cadence Quad SPI controller" > >> + depends on OF && (ARCH_SOCFPGA || COMPILE_TEST) > > > > I think you can remove the ARCH_SOCFPGA dependency as this driver is > > used on a TI EVM as well. > > I think above usage is correct. This will enable SPI_CADENCE_QUADSPI to > be selected when ARCH_SOCFPGA=y without having to enable COMPILE_TEST. > AFAIK, COMPILE_TEST is used usually to build test the driver w/o having > to enable ARCH specific configs (usually by maintainers). > For TI EVM, I would patch this file to add my architecture later(i.e > along with DT patch to my board). I changed this to OF && (ARM || COMPILE_TEST) , so that should be enough. Best regards, Marek Vasut