From: Ladislav Michl <ladis@linux-mips.org>
To: linux-mtd@lists.infradead.org, linux-omap@vger.kernel.org
Cc: Roger Quadros <rogerq@ti.com>, Tony Lindgren <tony@atomide.com>,
Peter Ujfalusi <peter.ujfalusi@ti.com>,
Boris Brezillon <boris.brezillon@free-electrons.com>,
Kyungmin Park <kyungmin.park@samsung.com>
Subject: [PATCH v4 16/16] ARM: dts: Nokia: Use R/B pin
Date: Sat, 11 Nov 2017 22:29:39 +0100 [thread overview]
Message-ID: <20171111212939.jcf26v3w26bd7sn7@lenoch> (raw)
In-Reply-To: <20171111211206.465pgorrjp3eyix6@lenoch>
Enable use of R/B pin. This is just experimental placeholder patch
as it lacks pinmux settings.
Signed-off-by: Ladislav Michl <ladis@linux-mips.org>
---
Changes:
-v4: new patch
arch/arm/boot/dts/omap2420-n8x0-common.dtsi | 4 +---
arch/arm/boot/dts/omap3-n900.dts | 1 +
2 files changed, 2 insertions(+), 3 deletions(-)
diff --git a/arch/arm/boot/dts/omap2420-n8x0-common.dtsi b/arch/arm/boot/dts/omap2420-n8x0-common.dtsi
index 843f6a2f5e29..cfe5d02ea0ed 100644
--- a/arch/arm/boot/dts/omap2420-n8x0-common.dtsi
+++ b/arch/arm/boot/dts/omap2420-n8x0-common.dtsi
@@ -42,14 +42,12 @@
&gpmc {
ranges = <0 0 0x04000000 0x1000000>; /* CS0: 16MB for OneNAND */
-
- /* gpio-irq for dma: 26 */
-
onenand@0,0 {
#address-cells = <1>;
#size-cells = <1>;
compatible = "ti,omap2-onenand";
reg = <0 0 0x20000>; /* CS0, offset 0, IO size 128K */
+ rb-gpios = <&gpio0 26 GPIO_ACTIVE_HIGH>;
gpmc,sync-read;
gpmc,burst-length = <16>;
diff --git a/arch/arm/boot/dts/omap3-n900.dts b/arch/arm/boot/dts/omap3-n900.dts
index aa5b1a439564..718116d9f4ac 100644
--- a/arch/arm/boot/dts/omap3-n900.dts
+++ b/arch/arm/boot/dts/omap3-n900.dts
@@ -840,6 +840,7 @@
#size-cells = <1>;
compatible = "ti,omap2-onenand";
reg = <0 0 0x20000>; /* CS0, offset 0, IO size 128K */
+ rb-gpios = <&gpio3 1 GPIO_ACTIVE_HIGH>;
gpmc,sync-read;
gpmc,sync-write;
--
2.11.0
next prev parent reply other threads:[~2017-11-11 21:30 UTC|newest]
Thread overview: 57+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-11-11 21:12 [PATCH v4 00/16] OMAP2+ OneNAND driver update Ladislav Michl
2017-11-11 21:17 ` [PATCH v4 02/16] ARM: dts: OMAP2+: Add compatible property to onenand node Ladislav Michl
2017-11-14 15:11 ` Roger Quadros
2017-11-14 23:01 ` Ladislav Michl
2017-11-14 21:39 ` Tony Lindgren
2017-11-11 21:18 ` [PATCH v4 03/16] ARM: dts: omap3-igep: Update onenand node timings Ladislav Michl
2017-11-14 15:12 ` Roger Quadros
2017-11-14 21:39 ` Tony Lindgren
2017-11-11 21:19 ` [PATCH v4 04/16] mtd: onenand: omap2: Remove regulator support Ladislav Michl
2017-11-14 15:13 ` Roger Quadros
2017-11-15 14:15 ` Sebastian Reichel
2017-11-11 21:19 ` [PATCH v4 05/16] mtd: onenand: omap2: Remove skip initial unlocking support Ladislav Michl
2017-11-14 15:14 ` Roger Quadros
2017-11-15 14:16 ` Sebastian Reichel
2017-11-11 21:20 ` [PATCH v4 06/16] mtd: onenand: omap2: Remove partitioning support from platform data Ladislav Michl
2017-11-14 15:14 ` Roger Quadros
2017-11-15 14:57 ` Sebastian Reichel
2017-11-11 21:20 ` [PATCH v4 07/16] mtd: onenand: omap2: Account waiting time as waiting on IO Ladislav Michl
2017-11-14 15:18 ` Roger Quadros
2017-11-15 15:00 ` Sebastian Reichel
2017-11-11 21:21 ` [PATCH v4 08/16] mtd: onenand: omap2: Simplify the DMA setup for various paths Ladislav Michl
2017-11-15 8:35 ` Roger Quadros
2017-11-15 15:05 ` Sebastian Reichel
2017-11-11 21:22 ` [PATCH v4 09/16] mtd: onenand: omap2: Unify OMAP2 and OMAP3 DMA implementation Ladislav Michl
2017-11-15 8:38 ` Roger Quadros
2017-11-15 15:07 ` Sebastian Reichel
2017-11-11 21:23 ` [PATCH v4 10/16] mtd: onenand: omap2: Convert to use dmaengine for memcpy Ladislav Michl
2017-11-15 8:57 ` Roger Quadros
2017-11-15 9:32 ` Ladislav Michl
2017-11-15 15:19 ` Sebastian Reichel
2017-11-11 21:24 ` [PATCH v4 11/16] mtd: onenand: omap2: Do not make delay for GPIO OMAP3 specific Ladislav Michl
2017-11-15 9:31 ` Roger Quadros
2017-11-15 15:20 ` Sebastian Reichel
2017-11-11 21:24 ` [PATCH v4 12/16] mtd: onenand: omap2: Enable DMA by default Ladislav Michl
2017-11-15 10:08 ` Roger Quadros
2017-11-15 10:32 ` Ladislav Michl
2017-11-15 10:43 ` Roger Quadros
2017-11-27 18:21 ` Ladislav Michl
2017-11-15 10:44 ` Roger Quadros
2017-11-11 21:26 ` [PATCH v4 13/16] memory: omap-gpmc: Refactor OneNAND support Ladislav Michl
2017-11-15 10:13 ` Roger Quadros
2017-11-15 10:37 ` Ladislav Michl
2017-11-11 21:27 ` [PATCH v4 14/16] mtd: onenand: omap2: Configure driver from DT Ladislav Michl
2017-11-15 10:40 ` Roger Quadros
2017-11-15 10:53 ` Ladislav Michl
2017-11-15 11:04 ` Roger Quadros
2017-11-15 11:20 ` Ladislav Michl
2017-11-15 14:41 ` Roger Quadros
2017-11-11 21:29 ` [PATCH v4 15/16] ARM: OMAP2+: Remove gpmc-onenand Ladislav Michl
2017-11-14 21:41 ` Tony Lindgren
2017-11-15 10:46 ` Roger Quadros
2017-11-11 21:29 ` Ladislav Michl [this message]
2017-11-14 21:42 ` [PATCH v4 16/16] ARM: dts: Nokia: Use R/B pin Tony Lindgren
2017-11-14 22:46 ` Ladislav Michl
2017-11-14 21:48 ` [PATCH v4 00/16] OMAP2+ OneNAND driver update Tony Lindgren
2017-11-14 22:53 ` Ladislav Michl
2017-11-15 8:10 ` Peter Ujfalusi
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20171111212939.jcf26v3w26bd7sn7@lenoch \
--to=ladis@linux-mips.org \
--cc=boris.brezillon@free-electrons.com \
--cc=kyungmin.park@samsung.com \
--cc=linux-mtd@lists.infradead.org \
--cc=linux-omap@vger.kernel.org \
--cc=peter.ujfalusi@ti.com \
--cc=rogerq@ti.com \
--cc=tony@atomide.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).