Re: [PATCH v8 0/5] mtd: cfi_cmdset_0002: Change write and erase functions

[Boris Brezillon <boris.brezillon@bootlin.com>]

On Wed, 30 May 2018 18:32:25 +0900
Tokunori Ikegami <ikegami@allied-telesis.co.jp> wrote:

> The changes are to make sure to check the operation status.
> Actually the flash write and erase error behavior is caused on our products.
> The flash is Macronix flash device MX29GL512FHT2I-11G used by our products.
> The patch series was separated for changes of flash write and erase.
> Since those were not depended each other at the time.
> But by additional changes the changes are related more as same way currently.
> So combine patch series for the flash write and erase changes as v6.

Applied to mtd/next.

Thanks,

Boris

> 
> Signed-off-by: Tokunori Ikegami <ikegami@allied-telesis.co.jp>
> Reviewed-by: Joakim Tjernlund <Joakim.Tjernlund@infinera.com>
> Cc: Chris Packham <chris.packham@alliedtelesis.co.nz>
> Cc: Brian Norris <computersforpeace@gmail.com>
> Cc: David Woodhouse <dwmw2@infradead.org>
> Cc: Boris Brezillon <boris.brezillon@free-electrons.com>
> Cc: Marek Vasut <marek.vasut@gmail.com>
> Cc: Richard Weinberger <richard@nod.at>
> Cc: Cyrille Pitchen <cyrille.pitchen@wedev4u.fr>
> Cc: linux-mtd@lists.infradead.org
> Cc: stable@vger.kernel.org
> 
> Tokunori Ikegami (5):
>   mtd: cfi_cmdset_0002: Change write buffer to check correct value
>   mtd: cfi_cmdset_0002: Change definition naming to retry write
>     operation
>   mtd: cfi_cmdset_0002: Change erase functions to retry for error
>   mtd: cfi_cmdset_0002: Change erase functions to check chip good only
>   mtd: cfi_cmdset_0002: Change erase one block to enable XIP once
> 
>  drivers/mtd/chips/cfi_cmdset_0002.c | 36 +++++++++++++++++++++++-------------
>  1 file changed, 23 insertions(+), 13 deletions(-)
>