[RFC PATCH v2 0/5] Fix and improve gpmi nand on mx28

[Dario Binacchi <dario.binacchi@amarulasolutions.com>]

Starting from [1], the series fixes the timings setting of the gpmi
controller for the mx28 architecture, also adding support for fast
edo mode timings. The whole series has been heavily tested with the
mtd kernel test modules, and with repeated write cycles on nand.

[1] https://lore.kernel.org/r/20210702065350.209646-5-ebiggers@kernel.org

Changes in v2:
 - Reparent by device tree instead of code (drivers/clk/mxs/clk-imx28.c).
   Suggested by Stephen Boyd.
- Improve the commit description.
- give examples of frequencies on my setup.
- Add the patch to the series.
- Fix commit description.
- Add an example to the commit description to better understand the
  problem solved by the patch.
- Split the patch.
- Improve the commit message.
- Move the patch to the end of the series.

Dario Binacchi (5):
  ARM: dts: imx28: reparent gpmi clock to ref_gpmi
  mtd: rawnand: gpmi: fix controller timings setting
  mtd: rawnand: gpmi: use a table to get EDO mode setup
  mtd: rawnand: gpmi: validate controller clock rate
  mtd: rawnand: gpmi: support fast edo timings for mx28

 arch/arm/boot/dts/imx28.dtsi               |  2 +
 drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c | 70 ++++++++++++++++------
 2 files changed, 55 insertions(+), 17 deletions(-)

-- 
2.32.0


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/