[Fwd: Re: Nand Flash driver for dedicated conroller]

[Fwd: Re: Nand Flash driver for dedicated conroller]

[Ajay Jain]

 

>>On Thu, 2005-07-14 at 05:28 -0700, Sunil Khandelwal
>>wrote:
>>    
>>
>>>I have an ARM based board, which has a flash
>>>controller on chip.
>>>
>>>There is no way I can control the signals like
>>>      
>>>
>>ALE, CE
>>    
>>
>>>etc to flash directly. 
>>>      
>>>

Hi, 

Even I have a similar problem, our flash controller does not allow us to control ALE, CLE etc, and the nand layer in mtd assumes that such a control is available. 
Our sandisk controller has exposed certain commands like Read, Write, Block Erase etc and it is does not allow any access to ALE. How can I use the current code to 
incorporate the controller.

Ajay

>  
>

Re: [Fwd: Re: Nand Flash driver for dedicated conroller]

[David Woodhouse]

Why is it that even after being referred to
http://david.woodhou.se/email.html you persist in posting this kind of
crap?

Look at your message -- http://david.woodhou.se/badmail1.jpeg

You leave blank lines at the top, you have an utterly unreadable mess
where you wrongly word-wrap the message to which you're replying, and
you have _more_ lines containing just '>>>' than actual text.

And then you add more lines of your own, which are far more than the
accepted norm of 76 characters each.

To top it all, you forward a message which had already been rejected
once, so it isn't even part of the correct thread.

Compare with what your mail _should_ have looked like, at
http://david.woodhou.se/badmail-fixed.jpeg 

I have asked you nicely once to conform to common netiquette, yet you
are still being lazy and rude. Keep it up and you will be barred from
the list.

-- 
dwmw2