From: mike lee <mikelee@avantwave.com>
To: linux-mtd@lists.infradead.org
Subject: Could not write to flash AT49BV6416T
Date: Mon, 07 Nov 2005 18:12:36 +0800 [thread overview]
Message-ID: <436F2894.2040104@avantwave.com> (raw)
Dear all
I can boot linux with this AT49BV6414T flash, but can not erase/write
to the flash. Every time i write to that flash it finish up with
"Input/Output Error".
Below is the debug output of cfi_cmdset0002, it is wrong according
to chip datasheet . I have tried to use JEDEC enabled kernel, the result
is the same.
By the way, that ATMEL flash is CFI version 1.0 , i don't know
whether it is update or not.
---- debug msg ---
NOR Flash 1: Found 1 x16 devices at 0x0 in 16-bit bank
Amd/Fujitsu Extended Query Table at 0x0041
Silicon revision: 87
Address sensitive unlock: Not required
Erase Suspend: Not supported
Block protection: Not supported
Temporary block unprotect: Supported
Block protect/unprotect scheme: 128
Number of simultaneous operations: 3
Burst mode: Supported
Page mode: 1020 word page
Vpp Supply Minimum Program/Erase Voltage: 15.15 V
Vpp Supply Maximum Program/Erase Voltage: 15.15 V
Top/Bottom Boot Block: Unknown value 255
NOR Flash 1: CFI does not contain boot bank location. Assuming top.
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
Thanks
Mike Lee
reply other threads:[~2005-11-07 10:22 UTC|newest]
Thread overview: [no followups] expand[flat|nested] mbox.gz Atom feed
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=436F2894.2040104@avantwave.com \
--to=mikelee@avantwave.com \
--cc=linux-mtd@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox