Re: [PATCH v8 2/3] MTD: add dt parameters for PMECC

[Josh Wu <josh.wu@atmel.com>]

On 5/23/2012 5:54 PM, Jean-Christophe PLAGNIOL-VILLARD wrote:
> On 15:47 Wed 23 May     , Josh Wu wrote:
>> Signed-off-by: Hong Xu<hong.xu@atmel.com>
>> Signed-off-by: Josh Wu<josh.wu@atmel.com>
>> ---
>>   .../devicetree/bindings/mtd/atmel-nand.txt         |    7 +++++++
>>   drivers/mtd/nand/atmel_nand.c                      |   20 ++++++++++++++++++++
>>   2 files changed, 27 insertions(+)
>>
>> diff --git a/Documentation/devicetree/bindings/mtd/atmel-nand.txt b/Documentation/devicetree/bindings/mtd/atmel-nand.txt
>> index a200695..895d72b 100644
>> --- a/Documentation/devicetree/bindings/mtd/atmel-nand.txt
>> +++ b/Documentation/devicetree/bindings/mtd/atmel-nand.txt
>> @@ -16,6 +16,12 @@ Optional properties:
>>   - nand-ecc-mode : String, operation mode of the NAND ecc mode, soft by default.
>>     Supported values are: "none", "soft", "hw", "hw_syndrome", "hw_oob_first",
>>     "soft_bch".
>> +- atmel,has-pmecc : boolean to enable Programmable Multibit ECC hardware.
>> +  Only supported by at91sam9x5 or later sam9 product.
>> +- atmel,pmecc-cap : error correct capability for Programmable Multibit ECC
>> +  Controller. Supported values are: 2, 4, 8, 12, 24.
>> +- atmel,sector-size : sector size for ECC computation. Supported values are:
>> +  512, 1024.
> pmecc-sector-size as it's pmecc specific

I'll change the name. thanks

> Best Regards,
> J.

Best Regards,
Josh Wu