From mboxrd@z Thu Jan 1 00:00:00 1970 Message-ID: <50F69289.8060401@mpl.ch> Date: Wed, 16 Jan 2013 12:44:09 +0100 From: Stefan Peter MIME-Version: 1.0 To: Jason Cooper Subject: Re: [PATCH 3/4] Enable ecc-mode selection in the driver References: <2d08c4c072fd4922a6056362adb96a455307d583.1358242644.git.s.peter@mpl.ch> <20130115123307.GA13433@titan.lakedaemon.net> In-Reply-To: <20130115123307.GA13433@titan.lakedaemon.net> Content-Type: text/plain; charset=ISO-8859-1 Content-Transfer-Encoding: 7bit Cc: andrew@lunn.ch, linux@arm.linux.org.uk, iwamatsu@nigauri.org, arnd@arndb.de, nico@linaro.org, artem.bityutskiy@linux.intel.com, devicetree-discuss@lists.ozlabs.org, broonie@opensource.wolfsonmicro.com, sebastian.hesselbarth@googlemail.com, linux-kernel@vger.kernel.org, rob.herring@calxeda.com, grant.likely@secretlab.ca, wfp5p@virginia.edu, linux-mtd@lists.infradead.org, rob@landley.net, gregkh@linuxfoundation.org, dwmw2@infradead.org, jm@lentin.co.uk, linux-arm-kernel@lists.infradead.org, mchehab@redhat.com List-Id: Linux MTD discussion mailing list List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Hi Jason on 15.01.2013 13:33, Jason Cooper wrote: > Stefan, > > This is a good-looking patch series, nice and small! A few comments: > > On Tue, Jan 15, 2013 at 01:13:12PM +0100, Stefan Peter wrote: >> In order to be able to use the ecc-mode, add the bch module to the default >> settings for the kirwood boards and enable the activation in orin-nand.c > > s/orin-nand/orion-nand/ Will fix. > >> >> Signed-off-by: Stefan Peter >> --- >> diff --git a/arch/arm/configs/kirkwood_defconfig b/arch/arm/configs/kirkwood_defconfig >> index 93f3794..4a9d3f7 100644 >> --- a/arch/arm/configs/kirkwood_defconfig >> +++ b/arch/arm/configs/kirkwood_defconfig >> @@ -84,6 +84,7 @@ CONFIG_MTD_CFI_STAA=y >> CONFIG_MTD_PHYSMAP=y >> CONFIG_MTD_M25P80=y >> CONFIG_MTD_NAND=y >> +CONFIG_MTD_NAND_ECC_BCH=y >> CONFIG_MTD_NAND_ORION=y >> CONFIG_BLK_DEV_LOOP=y >> # CONFIG_SCSI_PROC_FS is not set > > Please make the defconfig change a separate patch. Will do. > > As a general note (this series shouldn't be a problem), please sort the > series so that you add the driver feature first, then enable it in > defconfig, then use it in DT. This way, a future bisection won't run > into any nasty surprises, other than what they're looking for. ;-) Will do. Thank you very much for your review. Stefan Peter -- MPL AG, Switzerland http://www.mpl.ch Tel. +41 (0)56 483 34 34 Fax: +41(0)56 493 30 20