From mboxrd@z Thu Jan 1 00:00:00 1970 Received: from email.aftek.com ([128.121.126.111]) by pentafluge.infradead.org with esmtp (Exim 3.22 #1 (Red Hat Linux)) id 15DRkg-00089D-00 for ; Fri, 22 Jun 2001 15:17:38 +0100 Date: Fri, 22 Jun 2001 08:23:03 -0600 (MDT) From: ashwinp@aftek.com To: linux-mtd@lists.infradead.org Subject: Is my flash being detected? Message-Id: <993219781.58250@email.aftek.com> Sender: linux-mtd-admin@lists.infradead.org Errors-To: linux-mtd-admin@lists.infradead.org List-Help: List-Post: List-Subscribe: , List-Id: Linux MTD discussion mailing list List-Unsubscribe: , List-Archive: Hi freinds, I am trying to use mtd on L7205sdb.The flash chip used is AM29LV160DB. The flash size is 16 MB in byte mode and processor data bus being 32 bits wide. The .config for MTD is as below CONFIG_MTD=y CONFIG_MTD_DEBUG=y CONFIG_MTD_DEBUG_VERBOSE=3 CONFIG_MTD_CFI=y CONFIG_MTD_CFI_AMDEXT=y CONFIG_MTD_ROM=y CONFIG_MTD_PHYSMAP=y CONFIG_MTD_PHYSMAP_START=000000 CONFIG_MTD_PHYSMAP_LEN=10000 CONFIG_MTD_PHYSMAP_BUSWIDTH=4 It does say that AMd flash found but at the end it complains that "cfi_probe: No supported Vendor Command Set found" Given below are my bootup messages Linux version 2.2.1-rmk2 (root@localhost.localdomain) (libraries: /usr/local/arm/lib/gcc-lib/arm-linux/egcs-2.91.66/:/usr/lib/gcc/arm-linux/egcs-2.91.66/:/usr/local/arm/arm-linux/lib/arm-linux/egcs-2.91.66/:/usr/local/arm/arm-linux/lib/) #916 Fri Jun 22 17:51:46 IST 2001 start_kernl: Before setup_arch, 00000000-00000000