Re: [PATCH v4] mtd: spi-nor: micron-st: Add support for is25wx01g

["Nuno Sá" <nuno.sa@analog.com>]

On Thu, Nov 12, 2026 at 02:25:18AM +0000, Takahiro.Kuwano@infineon.com wrote:
> Hi,
> 
> > Add support for the ISSI IS25WX01G, a 1 Gbit (128 MiB) octal NOR flash.
> > The part is fully described by SFDP, so only the flash ID and small
> > post_bfpt and post_sfdp fixups are needed.
> > 
> > WRITE STATUS REGISTER (01h) takes a single data byte and only affects
> > status register bits 7:2, so the default 16-bit Write Status assumption
> > does not hold. Clear write_sr1_and_sr2 so that the single byte write_sr1
> > path is taken; write_sr1 is already set to 01h by the BFPT parsing.
> > 
> > The flash also has no Status Register 2. Configuration registers are read
> > with B5h/85h and written with B1h/81h, and the 35h Read Configuration
> > Register command does not exist, so clear read_sr2 as well.
> > 
> > Software write protection is done through the block protect bits in the
> > status register: BP0-BP2 at bits 4:2, BP3 at bit 6 and a Top/Bottom bit at
> > bit 5, which is exactly what SPI_NOR_HAS_LOCK, SPI_NOR_4BIT_BP,
> > SPI_NOR_BP3_SR_BIT6 and SPI_NOR_HAS_TB describe, so set those flags to get
> > the generic locking support.
> > 
> > The flash also supports 8D-8D-8D, but this could not be tested. Since the
> > SFDP has no SCCR map, the core would select 8D-8D-8D on a capable
> > controller but never switch the flash into it. Hence, drop the 8D-8D-8D
> > capabilities in a post_sfdp fixup for now.
> > 
> To fix missing SCCR map,
> 	.fixup_flags = SPI_NOR_IO_MODE_EN_VOLATILE
> is needed.

No sure I'm following... You mean that I could already set the flag
together with is25wx01g_post_sfdp_fixup()? I could do that but the only
advantage would less changes on a future patch enabling dtr.

> 
> Could you check if it works?

I can't test 8D-8D-8D for now... That is why I have the sfdp_fixup.
Please look at the comment in there where I do state we'll need to set
the SPI_NOR_IO_MODE_EN_VOLATILE for dtr to work.

- Nuno Sá

> 
> Thanks,
> Takahiro
> 

______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/