[BUG] mtd: rawnand: mircon: Cannot detect chip with commit 51f3b3970a8c

[Dinh Nguyen <dinguyen@kernel.org>]

Hi,

It looks like commit: "51f3b3970a8c mtd: rawnand: micron: detect forced
on-die ECC" is causing the NAND chip on the SoCFPGA Arria10 devkit to
stop working on linux-next.

If I revert the commit, then the NAND driver is able to detect the NAND
chip.

The NAND chip is a Micron MT29F1G08ABBEAH4 part.


[    0.741984] nand: device found, Manufacturer ID: 0x2c, Chip ID: 0xa1
[    0.748336] nand: Micron MT29F1G08ABBEAH4
[    0.752330] nand: 128 MiB, SLC, erase size: 128 KiB, page size: 2048,
OOB siz
e: 64
 [    0.763358] ecc.mode = 3
[    0.766312] On-die ECC forcefully enabled, not supported
[    0.771654] denali-nand-dt: probe of ffb90000.nand failed with error -22

With commit reverted:

[    0.742481] nand: device found, Manufacturer ID: 0x2c, Chip ID: 0xa1
[    0.748833] nand: Micron MT29F1G08ABBEAH4
[    0.752828] nand: 128 MiB, SLC, erase size: 128 KiB, page size: 2048,
OOB siz
e: 64
[    0.760610] Bad block table found at page 65472, version 0x01
[    0.766433] Bad block table found at page 65408, version 0x01
[    0.772464] 2 fixed-partitions partitions found on MTD device denali-nand
[    0.779247] Creating 2 MTD partitions on "denali-nand":
[    0.784453] 0x000000000000-0x000001c00000 : "Boot and fpga data"
[    0.791241] 0x000001c00000-0x000008000000 : "Root Filesystem - JFFS2"

Looks like if I comment out this part of the patch in
drivers/mtd/nand/raw/nand_micron.c

+#if 0
        for (i = 0; i < ARRAY_SIZE(micron_on_die_ecc); i++)
                if (chip->id.data[1] == micron_on_die_ecc[i])
                        return MICRON_ON_DIE_MANDATORY;
-
+#endif

then the driver is able to detect the NAND chip again.

Dinh