From mboxrd@z Thu Jan 1 00:00:00 1970 From: vimalsingh@ti.com (Vimal Singh) Date: Tue, 15 Dec 2009 21:10:54 +0530 Subject: [PATCH] OMAP: NAND: Adding config option to enable/disable HW ECC mode Message-ID: To: linux-mtd@lists.infradead.org List-Id: linux-mtd.lists.infradead.org This patch adds config option to select/deselect HW ECC feature on OMAP NAND driver. This is a feature provided by OMAP GPMC for NAND devices. Signed-off-by: Vimal Singh --- drivers/mtd/nand/Kconfig | 10 ++++++++++ 1 files changed, 10 insertions(+), 0 deletions(-) diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig index 34598e9..6c4b27c 100644 --- a/drivers/mtd/nand/Kconfig +++ b/drivers/mtd/nand/Kconfig @@ -97,6 +97,16 @@ config MTD_NAND_OMAP_PREFETCH_DMA or in DMA interrupt mode. Say y for DMA mode or MPU mode will be used +config MTD_NAND_OMAP_HWECC + bool "The Hardware ECC support" + depends on MTD_NAND && MTD_NAND_OMAP2 + default n + help + The ECC compuatation for the data to be written/read can be either by + software or omap has Hw ecc engine which calculates it. + MTD_NAND_OMAP_HWECC = y which enables the hw ecc + MTD_NAND_OMAP_HWECC = n enables software ecc + config MTD_NAND_TS7250 tristate "NAND Flash device on TS-7250 board" depends on MACH_TS72XX -- 1.5.5