From: "GA Dept PT ACBI" <hr_ga.dept@acbi.co.id>
To: 'Linux newbie list' <linux-newbie@vger.kernel.org>
Subject: ADSL connection via RHL 90
Date: Tue, 15 Feb 2005 15:14:53 +0700 [thread overview]
Message-ID: <000c01c51336$715254f0$6510ea0a@acbi.local> (raw)
I just installed RHL90, as workstation, and connected to our internal LAN.
Now, I tried to connect to the net via our ADSL. But failed, via Mozilla
browser, sendmail, or any other. The ADSL's IP number as default gateway was
already put into the routing table.
I can ping to the external IP number of my ISP ( i.e. 202.134.0.155 ), but
not to any external IP number ( e.g. 18.7.22.69 ). When I ping-ed to
external FQDN, it always said something like "...unknown host...".
Have I done something wrong during the installation? Where should I check
first?
Could somebody please help me?
My data is as follows :
Result of ifconfig :
eth0 Link encap:Ethernet HWaddr 00:0C:6E:6B:4E:C2
inet addr:10.234.16.101 Bcast:10.234.16.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4818 errors:0 dropped:0 overruns:0 frame:0
TX packets:502 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:583229 (569.5 Kb) TX bytes:42296 (41.3 Kb)
Interrupt:12 Base address:0xd000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:62168 errors:0 dropped:0 overruns:0 frame:0
TX packets:62168 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:4244648 (4.0 Mb) TX bytes:4244648 (4.0 Mb)
( note : 10.234.16.101 is my workstation's IP number. )
Result of route -v as follows :
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
10.234.16.0 * 255.255.255.0 U 0 0 0 eth0
169.254.0.0 * 255.255.0.0 U 0 0 0 eth0
127.0.0.0 * 255.0.0.0 U 0 0 0 lo
default 10.234.16.99 0.0.0.0 UG 0 0 0 eth0
route -C
Kernel IP routing cache
Source Destination Gateway Flags Metric Ref Use
Iface
fxrhl90 acbiserver.acbi acbiserver.acbi 0 0 17 eth0
fxrhl90 10.0.0.6 10.234.16.99 0 0 1 eth0
10.234.16.117 10.234.16.255 10.234.16.255 ibl 0 0 5 lo
fxrhl90 255.255.255.255 255.255.255.255 bl 0 0 9 eth0
10.234.16.100 10.234.16.255 10.234.16.255 ibl 0 0 2 lo
fxrhl90 10.234.16.104 10.234.16.104 0 0 2 eth0
10.234.16.135 10.234.16.255 10.234.16.255 ibl 0 0 14 lo
10.234.16.104 fxrhl90 fxrhl90 il 0 0 17 lo
10.234.16.105 10.234.16.255 10.234.16.255 ibl 0 0 1 lo
10.234.16.112 10.234.16.255 10.234.16.255 ibl 0 0 1 lo
10.234.16.104 10.234.16.255 10.234.16.255 ibl 0 0 0 lo
acbiserver.acbi fxrhl90 fxrhl90 il 0 0 25 lo
fxrhl90 fxrhl90 fxrhl90 l 0 0 98 lo
fxrhl90 10.234.16.104 10.234.16.104 0 0 2 eth0
fxrhl90 10.234.16.255 10.234.16.255 bl 0 0 2 eth0
fxrhl90 fxrhl90 fxrhl90 l 0 0 35 lo
fxrhl90 10.0.0.6 10.234.16.99 0 0 0 eth0
10.234.16.99 fxrhl90 fxrhl90 il 0 0 0 lo
acbiserver.acbi 10.234.16.255 10.234.16.255 ibl 0 0 0 lo
fxrhl90 acbiserver.acbi acbiserver.acbi 0 0 27 eth0
( note : fxrhl90 is the name of my workstation )
netstat -r :
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt
Iface
10.234.16.0 * 255.255.255.0 U 0 0 0
eth0
169.254.0.0 * 255.255.0.0 U 0 0 0
eth0
127.0.0.0 * 255.0.0.0 U 0 0 0 lo
default 10.234.16.99 0.0.0.0 UG 0 0 0
eth0
( note : I didn't input this 169.254.0.0 number; where does it come from ? )
Data from /etc/sysconfig/networking/devices/eth0.route as follows :
GATEWAY1=10.234.16.99
NETMASK1=255.255.0.0
ADDRESS1=202.134.2.5
GATEWAY0=10.234.16.99
NETMASK0=255.255.0.0
ADDRESS0=202.134.0.155
Data from /etc/sysconfig/networking/devices/ifcfg-eth0 :
DEVICE=eth0
BOOTPROTO=none
BROADCAST=10.234.16.255
IPADDR=10.234.16.101
NETMASK=255.255.255.0
NETWORK=10.234.16.0
ONBOOT=yes
HWADDR=00:0c:6e:6b:4e:c2
USERCTL=no
PEERDNS=no
GATEWAY=10.234.16.99
TYPE=Ethernet
Yours,
Frans T.
P.S.
Sorry for the use of bandwidth
----------------------------------------------------------------------------
This information is confidential and legally privileged. If you are not the
intended recipient, (i) please do not read or disclose to others,
(ii) please notify the sender by reply mail, and (iii) please delete this
communication from your system. Any review, retransmission, dissemination
or other use of, or taking of any action in reliance upon, this information
by persons or entities other than the intended recipient is prohibited.
Thank you for your cooperation.
----------------------------------------------------------------------------
-
To unsubscribe from this list: send the line "unsubscribe linux-newbie" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.linux-learn.org/faqs
next reply other threads:[~2005-02-15 8:14 UTC|newest]
Thread overview: 11+ messages / expand[flat|nested] mbox.gz Atom feed top
2005-02-15 8:14 GA Dept PT ACBI [this message]
2005-02-15 11:07 ` ADSL connection via RHL 90 Jim Nelson
2005-02-16 4:09 ` frans toruan
2005-02-15 16:08 ` chuck gelm
2005-02-16 4:09 ` frans toruan
2005-02-16 8:29 ` chuck gelm
2005-02-15 16:50 ` Ray Olszewski
2005-02-16 4:09 ` frans toruan
2005-02-16 5:39 ` Ray Olszewski
2005-02-16 9:35 ` frans toruan
2005-02-16 17:46 ` Ray Olszewski
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to='000c01c51336$715254f0$6510ea0a@acbi.local' \
--to=hr_ga.dept@acbi.co.id \
--cc=linux-newbie@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox