Re: IO

Jose Colmenares
2004-01-05T04:31:08Z

I'm writing this for the archive.
Found another card (similar to the one i had, but this
one works): rtl8029. To use a rtl8019 on linux you
have to set it in jumpless mode. Well, i believed you
did that with a software, so i looked all over, and
found some commands on DOS but where not recognize by
winXP. But when i took it off to install the other, it
had jumpers on it.
Next time, find all the hardware specifications! i
didn't have them because i was using a computer wich
had belonged to someone else and had lost practically
every manual. The rtl8019 sometimes is setup in
extrange io's by windows (i believe someone said
something like that on the list). In order for it to
work on linux you must set it in jumpless mode. So,
there was no way i was going to get it done!

Thanks everyone for the support. Hopefully, sometime
i'll be answering this questions! :)

_________________________________________________________
Do You Yahoo!?
Información de Estados Unidos y América Latina, en Yahoo! Noticias.
Visítanos en http://noticias.espanol.yahoo.com