From: Bilel DRIRA <bilel.dr@gmail.com>
To: marek.belisko@gmail.com, gregkh@linuxfoundation.org,
joe@perches.com, tapaswenipathak@gmail.com, gdonald@gmail.com,
aybuke.147@gmail.com, devel@driverdev.osuosl.org,
linux-kernel@vger.kernel.org, linux-next@vger.kernel.org
Cc: Bilel DRIRA <bilel.dr@gmail.com>
Subject: [PATCH] staging: ft1000: fix braces warning
Date: Tue, 3 Feb 2015 21:26:27 +0100 [thread overview]
Message-ID: <1422995187-4188-1-git-send-email-bilel.dr@gmail.com> (raw)
This patch fix checkpatch.pl WARNING:
WARNING: braces {} are not necessary for single statement blocks
Signed-off-by: Bilel DRIRA <bilel.dr@gmail.com>
---
drivers/staging/ft1000/ft1000-pcmcia/ft1000_hw.c | 73 +++++++++-------------
1 file changed, 29 insertions(+), 44 deletions(-)
diff --git a/drivers/staging/ft1000/ft1000-pcmcia/ft1000_hw.c b/drivers/staging/ft1000/ft1000-pcmcia/ft1000_hw.c
index e9a37ee..5897b59 100644
--- a/drivers/staging/ft1000/ft1000-pcmcia/ft1000_hw.c
+++ b/drivers/staging/ft1000/ft1000-pcmcia/ft1000_hw.c
@@ -204,11 +204,11 @@ static inline void ft1000_write_dpram_mag_16(struct net_device *dev,
/* Provide mutual exclusive access while reading ASIC registers. */
spin_lock_irqsave(&info->dpram_lock, flags);
ft1000_write_reg(dev, FT1000_REG_DPRAM_ADDR, offset);
- if (Index) {
+ if (Index)
ft1000_write_reg(dev, FT1000_REG_MAG_DPDATAL, value);
- } else {
+ else
ft1000_write_reg(dev, FT1000_REG_MAG_DPDATAH, value);
- }
+
spin_unlock_irqrestore(&info->dpram_lock, flags);
}
@@ -440,9 +440,8 @@ static int ft1000_reset_card(struct net_device *dev)
tempword =
ft1000_read_dpram_mag_16(dev, FT1000_MAG_DPRAM_FEFE,
FT1000_MAG_DPRAM_FEFE_INDX);
- if (tempword == 0xfefe) {
+ if (tempword == 0xfefe)
break;
- }
mdelay(20);
}
@@ -621,9 +620,9 @@ static void ft1000_hbchk(u_long data)
tempword = ft1000_read_reg(dev, FT1000_REG_DOORBELL);
/* Let's check doorbell again if fail */
- if (tempword & FT1000_DB_HB) {
+ if (tempword & FT1000_DB_HB)
tempword = ft1000_read_reg(dev, FT1000_REG_DOORBELL);
- }
+
if (tempword & FT1000_DB_HB) {
pr_info("heartbeat doorbell not clear by firmware\n");
if (info->AsicID == ELECTRABUZZ_ID) {
@@ -770,9 +769,8 @@ static void ft1000_send_cmd(struct net_device *dev, u16 *ptempbuffer, int size,
size += sizeof(struct pseudo_hdr);
/* check for odd byte and increment to 16-bit word align value */
- if ((size & 0x0001)) {
+ if ((size & 0x0001))
size++;
- }
pr_debug("total length = %d\n", size);
pr_debug("length = %d\n", ntohs(*ptempbuffer));
/*
@@ -915,9 +913,8 @@ static bool ft1000_receive_cmd(struct net_device *dev, u16 *pbuffer,
* Calculate pseudo header checksum
*/
tempword = *ppseudohdr++;
- for (i = 1; i < 7; i++) {
+ for (i = 1; i < 7; i++)
tempword ^= *ppseudohdr++;
- }
if ((tempword != *ppseudohdr)) {
pr_debug("Pseudo header checksum mismatch\n");
/* Drop this message */
@@ -982,9 +979,8 @@ static void ft1000_proc_drvmsg(struct net_device *dev)
while (tempword & FT1000_DB_DPRAM_TX) {
mdelay(5);
i++;
- if (i == 10) {
+ if (i == 10)
break;
- }
}
ptr =
list_entry(info->prov_list.next,
@@ -1105,9 +1101,8 @@ static void ft1000_proc_drvmsg(struct net_device *dev)
mdelay(10);
tempword =
ft1000_read_reg(dev, FT1000_REG_DOORBELL);
- if (tempword & FT1000_DB_DPRAM_TX) {
+ if (tempword & FT1000_DB_DPRAM_TX)
mdelay(10);
- }
}
if ((tempword & FT1000_DB_DPRAM_TX) == 0) {
@@ -1134,9 +1129,9 @@ static void ft1000_proc_drvmsg(struct net_device *dev)
ppseudo_hdr->portsrc = 0;
/* Calculate new checksum */
ppseudo_hdr->checksum = *pmsg++;
- for (i = 1; i < 7; i++) {
+ for (i = 1; i < 7; i++)
ppseudo_hdr->checksum ^= *pmsg++;
- }
+
info->DSPInfoBlk[8] = 0x7200;
info->DSPInfoBlk[9] =
htons(info->DSPInfoBlklen);
@@ -1156,9 +1151,8 @@ static void ft1000_proc_drvmsg(struct net_device *dev)
mdelay(10);
tempword =
ft1000_read_reg(dev, FT1000_REG_DOORBELL);
- if (tempword & FT1000_DB_DPRAM_TX) {
+ if (tempword & FT1000_DB_DPRAM_TX)
mdelay(10);
- }
}
if ((tempword & FT1000_DB_DPRAM_TX) == 0) {
@@ -1184,9 +1178,9 @@ static void ft1000_proc_drvmsg(struct net_device *dev)
ppseudo_hdr->portsrc = 0;
/* Calculate new checksum */
ppseudo_hdr->checksum = *pmsg++;
- for (i = 1; i < 7; i++) {
+ for (i = 1; i < 7; i++)
ppseudo_hdr->checksum ^= *pmsg++;
- }
+
pmsg = (u16 *)&tempbuffer[16];
*pmsg++ = htons(RSP_DRV_ERR_RPT_MSG);
*pmsg++ = htons(0x000e);
@@ -1508,9 +1502,8 @@ static void ft1000_flush_fifo(struct net_device *dev, u16 DrvErrNum)
tempword = inw(dev->base_addr + FT1000_REG_MAG_DFSR);
pr_debug("FT1000_REG_MAG_DFSR = 0x%x\n", tempword);
}
- if (DrvErrNum) {
+ if (DrvErrNum)
pcmcia->PktIntfErr++;
- }
}
}
@@ -1567,9 +1560,9 @@ static int ft1000_copy_up_pkt(struct net_device *dev)
if (skb == NULL) {
pr_debug("No Network buffers available\n");
/* Read High word to complete 32 bit access */
- if (info->AsicID == MAGNEMITE_ID) {
+ if (info->AsicID == MAGNEMITE_ID)
tempword = ft1000_read_reg(dev, FT1000_REG_MAG_DFRH);
- }
+
ft1000_flush_fifo(dev, 0);
info->stats.rx_errors++;
return FAILURE;
@@ -1673,9 +1666,8 @@ static int ft1000_copy_up_pkt(struct net_device *dev)
}
pr_debug("Data passed to Protocol layer:\n");
- for (i = 0; i < len + 12; i++) {
+ for (i = 0; i < len + 12; i++)
pr_debug("Protocol Data: 0x%x\n", *ptemp++);
- }
skb->dev = dev;
skb->protocol = eth_type_trans(skb, dev);
@@ -1729,21 +1721,16 @@ static int ft1000_copy_down_pkt(struct net_device *dev, u16 *packet, u16 len)
/* Check if there is room on the FIFO */
if (len > ft1000_read_fifo_len(dev)) {
udelay(10);
- if (len > ft1000_read_fifo_len(dev)) {
+ if (len > ft1000_read_fifo_len(dev))
udelay(20);
- }
- if (len > ft1000_read_fifo_len(dev)) {
+ if (len > ft1000_read_fifo_len(dev))
udelay(20);
- }
- if (len > ft1000_read_fifo_len(dev)) {
+ if (len > ft1000_read_fifo_len(dev))
udelay(20);
- }
- if (len > ft1000_read_fifo_len(dev)) {
+ if (len > ft1000_read_fifo_len(dev))
udelay(20);
- }
- if (len > ft1000_read_fifo_len(dev)) {
+ if (len > ft1000_read_fifo_len(dev))
udelay(20);
- }
if (len > ft1000_read_fifo_len(dev)) {
pr_debug("Transmit FIFO is full - pkt drop\n");
info->stats.tx_errors++;
@@ -1751,11 +1738,11 @@ static int ft1000_copy_down_pkt(struct net_device *dev, u16 *packet, u16 len)
}
}
/* Create pseudo header and send pseudo/ip to hardware */
- if (info->AsicID == ELECTRABUZZ_ID) {
+ if (info->AsicID == ELECTRABUZZ_ID)
pseudo.blk.length = len;
- } else {
+ else
pseudo.blk.length = ntohs(len);
- }
+
pseudo.blk.source = DSPID; /* Need to swap to get in correct order */
pseudo.blk.destination = HOSTID;
pseudo.blk.portdest = NETWORKID; /* Need to swap to get in correct order */
@@ -1768,9 +1755,8 @@ static int ft1000_copy_down_pkt(struct net_device *dev, u16 *packet, u16 len)
pseudo.blk.qos_class = 0;
/* Calculate pseudo header checksum */
pseudo.blk.checksum = pseudo.buff[0];
- for (i = 1; i < 7; i++) {
+ for (i = 1; i < 7; i++)
pseudo.blk.checksum ^= pseudo.buff[i];
- }
/* Production Mode */
if (info->AsicID == ELECTRABUZZ_ID) {
@@ -1835,9 +1821,8 @@ static int ft1000_copy_down_pkt(struct net_device *dev, u16 *packet, u16 len)
plong = (u32 *)packet;
/* Write PPP type + IP Packet into Downlink FIFO */
- for (i = 0; i < (len >> 2); i++) {
+ for (i = 0; i < (len >> 2); i++)
outl(*plong++, dev->base_addr + FT1000_REG_MAG_UFDR);
- }
/* Check for odd alignment */
if (len & 0x0003) {
--
1.7.9.5
next reply other threads:[~2015-02-03 20:26 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-02-03 20:26 Bilel DRIRA [this message]
-- strict thread matches above, loose matches on Subject: below --
2015-02-03 18:58 [PATCH] staging: ft1000: fix braces warning Bilel DRIRA
2015-02-03 19:05 ` Joe Perches
2015-02-03 20:05 ` bill
2015-02-03 20:14 ` Joe Perches
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1422995187-4188-1-git-send-email-bilel.dr@gmail.com \
--to=bilel.dr@gmail.com \
--cc=aybuke.147@gmail.com \
--cc=devel@driverdev.osuosl.org \
--cc=gdonald@gmail.com \
--cc=gregkh@linuxfoundation.org \
--cc=joe@perches.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-next@vger.kernel.org \
--cc=marek.belisko@gmail.com \
--cc=tapaswenipathak@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).