From: David Arendt <admin-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
To: NILFS Users mailing list <users-JrjvKiOkagjYtjvyW6yDsg@public.gmane.org>
Subject: Re: nilfs_cpfile_delete_checkpoints: cannot delete block
Date: Mon, 04 May 2009 06:16:24 +0200 [thread overview]
Message-ID: <49FE6C18.3050707@prnet.org> (raw)
In-Reply-To: <20090503.170847.69363313.ryusuke-sG5X7nlA6pw@public.gmane.org>
Hi,
This night. I had lots of:
nilfs_btree_propagate: key = 67, level == 0
On the parition where cleanerd has failed.
A try to umount it resulted in a hang with the following message:
NILFS warning (device sda10): nilfs_segctor_destroy: dirty file(s) after
the final construction
Bye,
David Arendt
Ryusuke Konishi wrote:
> Hi David,
> On Sun, 03 May 2009 00:55:43 +0200, David Arendt wrote:
>
>> Hi,
>>
>> Until now nilfs-2.0.12 has run very stable without data corruption.
>> However on one partition (600G) I have got the following errors while
>> running the cleaner:
>>
>> nilfs_cpfile_delete_checkpoints: cannot delete block
>> NILFS: GC failed during preparation: cannot delete checkpoints: err=-2
>>
>> This is a partition mainly holding large temporary render files (can be
>> up to 25gb/file). There are currently 132702 snapshots.
>>
>> As this partition is not used during the next few days, I will leave it
>> with the error so if you would like me to test further things, please
>> let me know.
>>
>> Bye,
>> David Arendt
>>
>
> I have reviewed the function in question, but could not find any
> likely problems.
>
> Could you try the following patch?
>
> It's applicable to v2.0.12.
>
> I have some pending patches later than 2.0.12, but they seem to be
> independent with your problem.
>
> Thanks,
> Ryusuke Konishi
> --
> diff --git a/fs/cpfile.c b/fs/cpfile.c
> index 038d660..9a6a6ae 100644
> --- a/fs/cpfile.c
> +++ b/fs/cpfile.c
> @@ -342,8 +342,12 @@ int nilfs_cpfile_delete_checkpoints(struct inode *cpfile,
> cpfile, cno);
> if (ret == 0)
> continue;
> - printk(KERN_ERR "%s: cannot delete block\n",
> - __func__);
> + printk(KERN_ERR "%s: cannot delete block: "
> + "cno=%llu, range = [%llu, %llu)\n",
> + __func__,
> + (unsigned long long)cno,
> + (unsigned long long)start,
> + (unsigned long long)end);
> goto out_sem;
> }
> }
> diff --git a/fs/dat.c b/fs/dat.c
> index 523eee7..7463301 100644
> --- a/fs/dat.c
> +++ b/fs/dat.c
> @@ -381,11 +381,9 @@ int nilfs_dat_translate(struct inode *dat, __u64 vblocknr, sector_t *blocknrp)
> entry = nilfs_palloc_block_get_entry(dat, vblocknr, entry_bh, kaddr);
> blocknr = le64_to_cpu(entry->de_blocknr);
> if (blocknr == 0) {
> -#ifdef CONFIG_NILFS_DEBUG
> printk(KERN_DEBUG "%s: invalid virtual block number: %llu\n",
> __func__, (unsigned long long)vblocknr);
> - BUG();
> -#endif
> + WARN_ON(1);
> ret = -ENOENT;
> goto out;
> }
>
next prev parent reply other threads:[~2009-05-04 4:16 UTC|newest]
Thread overview: 20+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-05-02 22:55 nilfs_cpfile_delete_checkpoints: cannot delete block David Arendt
[not found] ` <49FCCF6F.3040101-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-03 8:08 ` Ryusuke Konishi
[not found] ` <20090503.170847.69363313.ryusuke-sG5X7nlA6pw@public.gmane.org>
2009-05-03 9:26 ` David Arendt
[not found] ` <49FD6359.1020405-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-03 9:44 ` Ryusuke Konishi
[not found] ` <20090503.184449.53062216.ryusuke-sG5X7nlA6pw@public.gmane.org>
2009-05-03 10:06 ` David Arendt
2009-05-04 4:16 ` David Arendt [this message]
[not found] ` <49FE6C18.3050707-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-05 11:23 ` Ryusuke Konishi
-- strict thread matches above, loose matches on Subject: below --
2009-05-05 15:26 admin-/LHdS3kC8BfYtjvyW6yDsg
[not found] ` <D6LvKjCkn1gF.D60GTY3Z-GG6YVgmNXeLOQU1ULcgDhA@public.gmane.org>
2009-05-05 15:46 ` Ryusuke Konishi
[not found] ` <20090506.004648.105122016.ryusuke-sG5X7nlA6pw@public.gmane.org>
2009-05-05 16:51 ` David Arendt
[not found] ` <4A006EAB.6000206-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-05 19:32 ` David Arendt
[not found] ` <4A00944B.2020105-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-05 21:19 ` David Arendt
2009-05-06 3:02 ` Ryusuke Konishi
[not found] ` <20090506.120204.27533580.ryusuke-sG5X7nlA6pw@public.gmane.org>
2009-05-06 15:46 ` David Arendt
[not found] ` <4A01B0D2.6030509-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-10 5:43 ` Ryusuke Konishi
[not found] ` <20090510.144313.10164669.ryusuke-sG5X7nlA6pw@public.gmane.org>
2009-05-10 13:04 ` David Arendt
[not found] ` <4A06D0C4.5030008-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-10 15:40 ` Ryusuke Konishi
[not found] ` <20090511.004002.32775441.ryusuke-sG5X7nlA6pw@public.gmane.org>
2009-05-10 16:12 ` David Arendt
[not found] ` <4A06FCEB.7030800-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-11 0:57 ` Ryusuke Konishi
2009-05-10 9:10 ` Ryusuke Konishi
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=49FE6C18.3050707@prnet.org \
--to=admin-/lhds3kc8bfytjvyw6ydsg@public.gmane.org \
--cc=users-JrjvKiOkagjYtjvyW6yDsg@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox