[PATCH v9 01/29] scsi: core: Clear cmd->flags for terminal queuing error

[John Garry <john.garry@linux.dev>]

If a request can't be queued in scsi_queue_rq(), then we error out with
a blk_status_t code. Such a scenario may be the scsi_device has its
transport offline.

For BLK_STS_RESOURCE or BLK_STS_AGAIN, the request will be requeued in the
block layer. For other errors, the block layer ends the request and so
we won't see it again (until recycled).

Normally when a request completes scmd->flags is cleared in
scsi_end_request().

However for the error scenario mentioned above, scsi_end_request() is
not called and so scmd->flags is not cleared. As such, when the request
is recycled we see the old value in scmd->flags.

Fix this issue by clearing scmd->flags in the error scenario mentioned by
calling scsi_cleanup_rq().

Signed-off-by: John Garry <john.garry@linux.dev>
---
 drivers/scsi/scsi_lib.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/scsi/scsi_lib.c b/drivers/scsi/scsi_lib.c
index b52b4c5daa42..36bc995e4e25 100644
--- a/drivers/scsi/scsi_lib.c
+++ b/drivers/scsi/scsi_lib.c
@@ -1994,8 +1994,8 @@ static blk_status_t scsi_queue_rq(struct blk_mq_hw_ctx *hctx,
 		 * we hit an error, as we will never see this command
 		 * again.
 		 */
-		if (req->rq_flags & RQF_DONTPREP)
-			scsi_mq_uninit_cmd(cmd);
+		scsi_cleanup_rq(req);
+
 		scsi_run_queue_async(sdev);
 		break;
 	}
-- 
2.43.0