Re: nvme nvme0: I/O 0 (I/O Cmd) QID 1 timeout, aborting, source drive corruption observed

["J. Hart" <jfhart085@gmail.com>]

I've tried the obvious ones and that didn't help either.  I guess I'll 
have to give up on it and return it as defective.  I'll go back to 
normal operation and to try and find a controller/device combination 
that works with the linux driver if there are any.

In any case, thanks again very much for your kind assistance.

J. Hart

On 12/16/22 2:34 AM, Keith Busch wrote:
> On Thu, Dec 15, 2022 at 10:33:30PM +0900, J. Hart wrote:
>> [ +26.890018] nvme nvme0: I/O 0 (Write) QID 1 timeout, aborting
>> [Dec15 21:35] nvme nvme0: I/O 0 QID 1 timeout, reset controller
>> [ +30.719998] nvme nvme0: I/O 13 QID 0 timeout, reset controller
>> [Dec15 21:38] nvme nvme0: Device not ready; aborting reset, CSTS=0x1
>> [  +0.014796] nvme nvme0: Abort status: 0x371
>> [Dec15 21:40] nvme nvme0: Device not ready; aborting reset, CSTS=0x1
>> [  +0.000024] nvme nvme0: Removing after probe failure status: -19
>> [Dec15 21:42] nvme nvme0: Device not ready; aborting reset, CSTS=0x1
>> [  +0.000324] nvme0n1: detected capacity change from 976773168 to 0
> 
> This looks like your device is completely unresponsive: no ack to IO
> commands, admin commands, or reset sequences. Unfortunately these are
> typically firmware bugs. Without additional guidance from the vendor,
> we don't really have many options to try from the driver: just disabling
> some optional power and performance capabilities, though that often
> doesn't help either.