RE: [PATCH 12/17] OMAP2/3: Do not enable AUTOIDLE in interrupt controller

["Girish S G" <girishsg@ti.com>]

> -----Original Message-----
> From: linux-omap-owner@vger.kernel.org [mailto:linux-omap-owner@vger.kernel.org] On Behalf Of
> Woodruff, Richard
> Sent: Friday, October 16, 2009 9:40 AM
> To: Tero Kristo; linux-omap@vger.kernel.org
> Cc: Jouni Hogander
> Subject: RE: [PATCH 12/17] OMAP2/3: Do not enable AUTOIDLE in interrupt controller
> 
> 
> > From: linux-omap-owner@vger.kernel.org [mailto:linux-omap-
> > owner@vger.kernel.org] On Behalf Of Tero Kristo
> > Sent: Friday, October 16, 2009 5:49 AM
> 
> > OMAP interrupt controller goes to unknown state when there is right
> > combination of l3,l4 sleep/wake-up transitions, l4 autoidle in
> > interrupt controller and some interrupt. When this happens, interrupts
> > are not delivered to ARM anymore and ARM will remain in WFI (wait for
> > interrupt) until interrupt controller is forced to wake-up
> > (i.e. lauterbach). Disable AUTOIDLE in INTC for now.
> 
> Optimal work around enables and disables this around WFI.

On one of the custom board the power measured didn't show any major impact, with just one time disabling of INTC-AUTOIDL. However,
optimizing this WA looks good though. I did give it a try,
Disabling/enabling INTC autoidle around WFI on custom board, works well but didn't get chance to
measure the numbers.

Regards,
-Girish