From: Tony Lindgren <tony@atomide.com>
To: linux-omap-open-source@linux.omap.com
Subject: [PATCH 8/52] musb_hdrc: Search and replace pDest with dst
Date: Mon, 13 Aug 2007 06:48:43 -0700 [thread overview]
Message-ID: <118701298833-git-send-email-tony@atomide.com> (raw)
In-Reply-To: <11870129861917-git-send-email-tony@atomide.com>
Search and replace pDest with dst
Signed-off-by: Tony Lindgren <tony@atomide.com>
---
drivers/usb/musb/musbdefs.h | 2 +-
drivers/usb/musb/plat_uds.c | 18 +++++++++---------
2 files changed, 10 insertions(+), 10 deletions(-)
--- a/drivers/usb/musb/musbdefs.h
+++ b/drivers/usb/musb/musbdefs.h
@@ -502,7 +502,7 @@ extern void musb_stop(struct musb *musb);
extern void musb_write_fifo(struct musb_hw_ep *ep,
u16 wCount, const u8 * src);
extern void musb_read_fifo(struct musb_hw_ep *ep,
- u16 wCount, u8 * pDest);
+ u16 wCount, u8 * dst);
extern void musb_load_testpacket(struct musb *);
--- a/drivers/usb/musb/plat_uds.c
+++ b/drivers/usb/musb/plat_uds.c
@@ -209,38 +209,38 @@ void musb_write_fifo(struct musb_hw_ep *hw_ep, u16 wCount, const u8 *src)
/*
* Unload an endpoint's FIFO
*/
-void musb_read_fifo(struct musb_hw_ep *hw_ep, u16 wCount, u8 *pDest)
+void musb_read_fifo(struct musb_hw_ep *hw_ep, u16 wCount, u8 *dst)
{
void __iomem *fifo = hw_ep->fifo;
DBG(4, "%cX ep%d fifo %p count %d buf %p\n",
- 'R', hw_ep->bLocalEnd, fifo, wCount, pDest);
+ 'R', hw_ep->bLocalEnd, fifo, wCount, dst);
/* we can't assume unaligned writes work */
- if (likely((0x01 & (unsigned long) pDest) == 0)) {
+ if (likely((0x01 & (unsigned long) dst) == 0)) {
u16 index = 0;
/* best case is 32bit-aligned destination address */
- if ((0x02 & (unsigned long) pDest) == 0) {
+ if ((0x02 & (unsigned long) dst) == 0) {
if (wCount >= 4) {
- readsl(fifo, pDest, wCount >> 2);
+ readsl(fifo, dst, wCount >> 2);
index = wCount & ~0x03;
}
if (wCount & 0x02) {
- *(u16*)&pDest[index] = musb_readw(fifo, 0);
+ *(u16*)&dst[index] = musb_readw(fifo, 0);
index += 2;
}
} else {
if (wCount >= 2) {
- readsw(fifo, pDest, wCount >> 1);
+ readsw(fifo, dst, wCount >> 1);
index = wCount & ~0x01;
}
}
if (wCount & 0x01)
- pDest[index] = musb_readb(fifo, 0);
+ dst[index] = musb_readb(fifo, 0);
} else {
/* byte aligned */
- readsb(fifo, pDest, wCount);
+ readsb(fifo, dst, wCount);
}
}
--
1.5.2.3
next prev parent reply other threads:[~2007-08-13 13:48 UTC|newest]
Thread overview: 57+ messages / expand[flat|nested] mbox.gz Atom feed top
2007-08-13 13:48 (no subject) Tony Lindgren
2007-08-13 13:48 ` [PATCH 1/52] musb_hdrc: Search and replace pThis with musb Tony Lindgren
2007-08-13 13:48 ` [PATCH 2/52] musb_hdrc: Search and replace pEndPt with hw_ep Tony Lindgren
2007-08-13 13:48 ` [PATCH 3/52] musb_hdrc: Search and replace pEnd with musb_ep when struct musb_ep Tony Lindgren
2007-08-13 13:48 ` [PATCH 4/52] musb_hdrc: Search and replace pEnd with musb_ep when struct musb_hw_ep Tony Lindgren
2007-08-13 13:48 ` [PATCH 5/52] musb_hdrc: Search and replace pRegs with mregs Tony Lindgren
2007-08-13 13:48 ` [PATCH 6/52] musb_hdrc: Search and replace pBase with mbase Tony Lindgren
2007-08-13 13:48 ` [PATCH 7/52] musb_hdrc: Search and replace pSource with src Tony Lindgren
2007-08-13 13:48 ` Tony Lindgren [this message]
2007-08-13 13:48 ` [PATCH 9/52] musb_hdrc: Search and replace dwCount with len Tony Lindgren
2007-08-13 13:48 ` [PATCH 10/52] musb_hdrc: Search and replace wFifoCount with fifo_count Tony Lindgren
2007-08-13 13:48 ` [PATCH 11/52] musb_hdrc: Search and replace wCount with len Tony Lindgren
2007-08-13 13:48 ` [PATCH 12/52] musb_hdrc: Search and replace bLocalEnd with epnum Tony Lindgren
2007-08-13 13:48 ` [PATCH 13/52] musb_hdrc: Search and replace aLocalEnd with endpoints Tony Lindgren
2007-08-13 13:48 ` [PATCH 14/52] musb_hdrc: Search and replace bEndCount with nr_endpoints Tony Lindgren
2007-08-13 13:48 ` [PATCH 15/52] musb_hdrc: Search and replace bEndNumber with current_epnum Tony Lindgren
2007-08-13 13:48 ` [PATCH 16/52] musb_hdrc: Search and replace bEnd0Stage with ep0_stage Tony Lindgren
2007-08-13 13:48 ` [PATCH 17/52] musb_hdrc: Search and replace bEnd with epnum Tony Lindgren
2007-08-13 13:48 ` [PATCH 18/52] musb_hdrc: Search and replace Lock with lock Tony Lindgren
2007-08-13 13:48 ` [PATCH 19/52] musb_hdrc: Search and replace MGC_SelectEnd with musb_ep_select Tony Lindgren
2007-08-13 13:48 ` [PATCH 20/52] musb_hdrc: Search and replace _pthis with _musb Tony Lindgren
2007-08-13 13:48 ` [PATCH 21/52] musb_hdrc: Search and replace bIsHost with is_host Tony Lindgren
2007-08-13 13:48 ` [PATCH 22/52] musb_hdrc: Get rid of old unused MUSB_EpFifoDescriptor Tony Lindgren
2007-08-13 13:48 ` [PATCH 23/52] musb_hdrc: Search and replace bIsSharedFifo with is_shared_fifo Tony Lindgren
2007-08-13 13:48 ` [PATCH 24/52] musb_hdrc: Search and replace wMaxPacketSizeTx with max_packet_sz_tx Tony Lindgren
2007-08-13 13:49 ` [PATCH 25/52] musb_hdrc: Search and replace wMaxPacketSizeRx with max_packet_sz_rx Tony Lindgren
2007-08-13 13:49 ` [PATCH 26/52] musb_hdrc: Search and replace pDmaController with dma_controller Tony Lindgren
2007-08-13 13:49 ` [PATCH 27/52] musb_hdrc: Search and replace bIsMultipoint with is_multipoint Tony Lindgren
2007-08-13 13:49 ` [PATCH 28/52] musb_hdrc: Search and replace bIgnoreDisconnect with ignore_disconnect Tony Lindgren
2007-08-13 13:49 ` [PATCH 29/52] musb_hdrc: Search and replace bBulkSplit with bulk_split Tony Lindgren
2007-08-13 13:49 ` [PATCH 30/52] musb_hdrc: Search and replace bBulkCombine with bulk_combine Tony Lindgren
2007-08-13 13:49 ` [PATCH 31/52] musb_hdrc: Search and replace bAddress with address Tony Lindgren
2007-08-13 13:49 ` [PATCH 32/52] musb_hdrc: Search and replace bTestModeValue with test_mode_nr Tony Lindgren
2007-08-13 13:49 ` [PATCH 33/52] musb_hdrc: Search and replace bTestMode with test_mode Tony Lindgren
2007-08-13 13:49 ` [PATCH 34/52] musb_hdrc: Search and replace pGadgetDriver with gadget_driver Tony Lindgren
2007-08-13 13:49 ` [PATCH 35/52] musb_hdrc: Search and replace bDelayPortPowerOff with delay_port_power_off Tony Lindgren
2007-08-13 13:49 ` [PATCH 36/52] musb_hdrc: Search and replace pProcEntry with proc_entry Tony Lindgren
2007-08-13 13:49 ` [PATCH 37/52] musb_hdrc: Search and replace pPrivateData with private_data Tony Lindgren
2007-08-13 13:49 ` [PATCH 38/52] musb_hdrc: Search and replace dwMaxLength with max_len Tony Lindgren
2007-08-13 13:49 ` [PATCH 39/52] musb_hdrc: Search and replace dwActualLength with actual_len Tony Lindgren
2007-08-13 13:49 ` [PATCH 40/52] musb_hdrc: Search and replace bStatus with status Tony Lindgren
2007-08-13 13:49 ` [PATCH 41/52] musb_hdrc: Search and replace bDesiredMode with desired_mode Tony Lindgren
2007-08-13 13:49 ` [PATCH 42/52] musb_hdrc: Search and replace bMode with mode Tony Lindgren
2007-08-13 13:49 ` [PATCH 43/52] musb_hdrc: Search and replace MGC_pfDmaProgramChannel with dma_program_channel Tony Lindgren
2007-08-13 13:49 ` [PATCH 44/52] musb_hdrc: Search and replace pControlRequest with ctrlrequest Tony Lindgren
2007-08-13 13:49 ` [PATCH 45/52] musb_hdrc: Search and replace bResult with result Tony Lindgren
2007-08-13 13:49 ` [PATCH 46/52] musb_hdrc: Search and replace bSetAddress with set_address Tony Lindgren
2007-08-13 13:49 ` [PATCH 47/52] musb_hdrc: Search and replace bRecip with recip Tony Lindgren
2007-08-13 13:49 ` [PATCH 48/52] musb_hdrc: Search and replace pRequest with request Tony Lindgren
2007-08-13 13:49 ` [PATCH 49/52] musb_hdrc: Search and replace wCsrVal with csr Tony Lindgren
2007-08-13 13:49 ` [PATCH 50/52] musb_hdrc: Search and replace bTx with tx Tony Lindgren
2007-08-13 13:49 ` [PATCH 51/52] musb_hdrc: Search and replace wPacketSize with packet_sz Tony Lindgren
2007-08-13 13:49 ` [PATCH 52/52] musb_hdrc: Search and replace channelNum with chnum Tony Lindgren
2007-08-14 9:23 ` [PATCH 4/52] musb_hdrc: Search and replace pEnd with musb_ep when struct musb_hw_ep Tony Lindgren
2007-08-13 13:58 ` (no subject) Felipe Balbi
2007-08-14 8:06 ` musb CaMeLcAsEnOmOre (was: (no subject)) David Brownell
2007-08-14 8:55 ` Tony Lindgren
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=118701298833-git-send-email-tony@atomide.com \
--to=tony@atomide.com \
--cc=linux-omap-open-source@linux.omap.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox