From: Tony Lindgren <tony@atomide.com>
To: linux-omap-open-source@linux.omap.com
Subject: [PATCH 31/52] musb_hdrc: Search and replace bAddress with address
Date: Mon, 13 Aug 2007 06:49:06 -0700 [thread overview]
Message-ID: <11870130521115-git-send-email-tony@atomide.com> (raw)
In-Reply-To: <1187013048432-git-send-email-tony@atomide.com>
Search and replace bAddress with address
Signed-off-by: Tony Lindgren <tony@atomide.com>
---
drivers/usb/musb/g_ep0.c | 4 ++--
drivers/usb/musb/musb_gadget.c | 2 +-
drivers/usb/musb/musb_host.c | 4 ++--
drivers/usb/musb/musbdefs.h | 2 +-
4 files changed, 6 insertions(+), 6 deletions(-)
--- a/drivers/usb/musb/g_ep0.c
+++ b/drivers/usb/musb/g_ep0.c
@@ -240,7 +240,7 @@ __acquires(musb->lock)
case USB_REQ_SET_ADDRESS:
/* change it after the status stage */
musb->bSetAddress = TRUE;
- musb->bAddress = (u8) (pControlRequest->wValue & 0x7f);
+ musb->address = (u8) (pControlRequest->wValue & 0x7f);
handled = 1;
break;
@@ -663,7 +663,7 @@ irqreturn_t musb_g_ep0_irq(struct musb *musb)
*/
if (musb->bSetAddress) {
musb->bSetAddress = FALSE;
- musb_writeb(mbase, MGC_O_HDRC_FADDR, musb->bAddress);
+ musb_writeb(mbase, MGC_O_HDRC_FADDR, musb->address);
}
/* enter test mode if needed (exit by reset) */
--- a/drivers/usb/musb/musb_gadget.c
+++ b/drivers/usb/musb/musb_gadget.c
@@ -2010,7 +2010,7 @@ __acquires(musb->lock)
musb->is_active = 1;
musb->is_suspended = 0;
MUSB_DEV_MODE(musb);
- musb->bAddress = 0;
+ musb->address = 0;
musb->ep0_state = MGC_END0_STAGE_SETUP;
musb->may_wakeup = 0;
--- a/drivers/usb/musb/musb_host.c
+++ b/drivers/usb/musb/musb_host.c
@@ -176,7 +176,7 @@ musb_start_urb(struct musb *musb, int is_in, struct musb_qh *qh)
struct urb *urb = next_urb(qh);
struct musb_hw_ep *hw_ep = qh->hw_ep;
unsigned nPipe = urb->pipe;
- u8 bAddress = usb_pipedevice(nPipe);
+ u8 address = usb_pipedevice(nPipe);
int epnum = hw_ep->epnum;
/* initialize software qh state */
@@ -205,7 +205,7 @@ musb_start_urb(struct musb *musb, int is_in, struct musb_qh *qh)
}
DBG(4, "qh %p urb %p dev%d ep%d%s%s, hw_ep %d, %p/%d\n",
- qh, urb, bAddress, qh->epnum,
+ qh, urb, address, qh->epnum,
is_in ? "in" : "out",
({char *s; switch (qh->type) {
case USB_ENDPOINT_XFER_CONTROL: s = ""; break;
--- a/drivers/usb/musb/musbdefs.h
+++ b/drivers/usb/musb/musbdefs.h
@@ -442,7 +442,7 @@ struct musb {
unsigned softconnect:1;
enum musb_g_ep0_state ep0_state;
- u8 bAddress;
+ u8 address;
u8 bTestModeValue;
u16 ackpend; /* ep0 */
struct usb_gadget g; /* the gadget */
--
1.5.2.3
next prev parent reply other threads:[~2007-08-13 13:49 UTC|newest]
Thread overview: 57+ messages / expand[flat|nested] mbox.gz Atom feed top
2007-08-13 13:48 (no subject) Tony Lindgren
2007-08-13 13:48 ` [PATCH 1/52] musb_hdrc: Search and replace pThis with musb Tony Lindgren
2007-08-13 13:48 ` [PATCH 2/52] musb_hdrc: Search and replace pEndPt with hw_ep Tony Lindgren
2007-08-13 13:48 ` [PATCH 3/52] musb_hdrc: Search and replace pEnd with musb_ep when struct musb_ep Tony Lindgren
2007-08-13 13:48 ` [PATCH 4/52] musb_hdrc: Search and replace pEnd with musb_ep when struct musb_hw_ep Tony Lindgren
2007-08-13 13:48 ` [PATCH 5/52] musb_hdrc: Search and replace pRegs with mregs Tony Lindgren
2007-08-13 13:48 ` [PATCH 6/52] musb_hdrc: Search and replace pBase with mbase Tony Lindgren
2007-08-13 13:48 ` [PATCH 7/52] musb_hdrc: Search and replace pSource with src Tony Lindgren
2007-08-13 13:48 ` [PATCH 8/52] musb_hdrc: Search and replace pDest with dst Tony Lindgren
2007-08-13 13:48 ` [PATCH 9/52] musb_hdrc: Search and replace dwCount with len Tony Lindgren
2007-08-13 13:48 ` [PATCH 10/52] musb_hdrc: Search and replace wFifoCount with fifo_count Tony Lindgren
2007-08-13 13:48 ` [PATCH 11/52] musb_hdrc: Search and replace wCount with len Tony Lindgren
2007-08-13 13:48 ` [PATCH 12/52] musb_hdrc: Search and replace bLocalEnd with epnum Tony Lindgren
2007-08-13 13:48 ` [PATCH 13/52] musb_hdrc: Search and replace aLocalEnd with endpoints Tony Lindgren
2007-08-13 13:48 ` [PATCH 14/52] musb_hdrc: Search and replace bEndCount with nr_endpoints Tony Lindgren
2007-08-13 13:48 ` [PATCH 15/52] musb_hdrc: Search and replace bEndNumber with current_epnum Tony Lindgren
2007-08-13 13:48 ` [PATCH 16/52] musb_hdrc: Search and replace bEnd0Stage with ep0_stage Tony Lindgren
2007-08-13 13:48 ` [PATCH 17/52] musb_hdrc: Search and replace bEnd with epnum Tony Lindgren
2007-08-13 13:48 ` [PATCH 18/52] musb_hdrc: Search and replace Lock with lock Tony Lindgren
2007-08-13 13:48 ` [PATCH 19/52] musb_hdrc: Search and replace MGC_SelectEnd with musb_ep_select Tony Lindgren
2007-08-13 13:48 ` [PATCH 20/52] musb_hdrc: Search and replace _pthis with _musb Tony Lindgren
2007-08-13 13:48 ` [PATCH 21/52] musb_hdrc: Search and replace bIsHost with is_host Tony Lindgren
2007-08-13 13:48 ` [PATCH 22/52] musb_hdrc: Get rid of old unused MUSB_EpFifoDescriptor Tony Lindgren
2007-08-13 13:48 ` [PATCH 23/52] musb_hdrc: Search and replace bIsSharedFifo with is_shared_fifo Tony Lindgren
2007-08-13 13:48 ` [PATCH 24/52] musb_hdrc: Search and replace wMaxPacketSizeTx with max_packet_sz_tx Tony Lindgren
2007-08-13 13:49 ` [PATCH 25/52] musb_hdrc: Search and replace wMaxPacketSizeRx with max_packet_sz_rx Tony Lindgren
2007-08-13 13:49 ` [PATCH 26/52] musb_hdrc: Search and replace pDmaController with dma_controller Tony Lindgren
2007-08-13 13:49 ` [PATCH 27/52] musb_hdrc: Search and replace bIsMultipoint with is_multipoint Tony Lindgren
2007-08-13 13:49 ` [PATCH 28/52] musb_hdrc: Search and replace bIgnoreDisconnect with ignore_disconnect Tony Lindgren
2007-08-13 13:49 ` [PATCH 29/52] musb_hdrc: Search and replace bBulkSplit with bulk_split Tony Lindgren
2007-08-13 13:49 ` [PATCH 30/52] musb_hdrc: Search and replace bBulkCombine with bulk_combine Tony Lindgren
2007-08-13 13:49 ` Tony Lindgren [this message]
2007-08-13 13:49 ` [PATCH 32/52] musb_hdrc: Search and replace bTestModeValue with test_mode_nr Tony Lindgren
2007-08-13 13:49 ` [PATCH 33/52] musb_hdrc: Search and replace bTestMode with test_mode Tony Lindgren
2007-08-13 13:49 ` [PATCH 34/52] musb_hdrc: Search and replace pGadgetDriver with gadget_driver Tony Lindgren
2007-08-13 13:49 ` [PATCH 35/52] musb_hdrc: Search and replace bDelayPortPowerOff with delay_port_power_off Tony Lindgren
2007-08-13 13:49 ` [PATCH 36/52] musb_hdrc: Search and replace pProcEntry with proc_entry Tony Lindgren
2007-08-13 13:49 ` [PATCH 37/52] musb_hdrc: Search and replace pPrivateData with private_data Tony Lindgren
2007-08-13 13:49 ` [PATCH 38/52] musb_hdrc: Search and replace dwMaxLength with max_len Tony Lindgren
2007-08-13 13:49 ` [PATCH 39/52] musb_hdrc: Search and replace dwActualLength with actual_len Tony Lindgren
2007-08-13 13:49 ` [PATCH 40/52] musb_hdrc: Search and replace bStatus with status Tony Lindgren
2007-08-13 13:49 ` [PATCH 41/52] musb_hdrc: Search and replace bDesiredMode with desired_mode Tony Lindgren
2007-08-13 13:49 ` [PATCH 42/52] musb_hdrc: Search and replace bMode with mode Tony Lindgren
2007-08-13 13:49 ` [PATCH 43/52] musb_hdrc: Search and replace MGC_pfDmaProgramChannel with dma_program_channel Tony Lindgren
2007-08-13 13:49 ` [PATCH 44/52] musb_hdrc: Search and replace pControlRequest with ctrlrequest Tony Lindgren
2007-08-13 13:49 ` [PATCH 45/52] musb_hdrc: Search and replace bResult with result Tony Lindgren
2007-08-13 13:49 ` [PATCH 46/52] musb_hdrc: Search and replace bSetAddress with set_address Tony Lindgren
2007-08-13 13:49 ` [PATCH 47/52] musb_hdrc: Search and replace bRecip with recip Tony Lindgren
2007-08-13 13:49 ` [PATCH 48/52] musb_hdrc: Search and replace pRequest with request Tony Lindgren
2007-08-13 13:49 ` [PATCH 49/52] musb_hdrc: Search and replace wCsrVal with csr Tony Lindgren
2007-08-13 13:49 ` [PATCH 50/52] musb_hdrc: Search and replace bTx with tx Tony Lindgren
2007-08-13 13:49 ` [PATCH 51/52] musb_hdrc: Search and replace wPacketSize with packet_sz Tony Lindgren
2007-08-13 13:49 ` [PATCH 52/52] musb_hdrc: Search and replace channelNum with chnum Tony Lindgren
2007-08-14 9:23 ` [PATCH 4/52] musb_hdrc: Search and replace pEnd with musb_ep when struct musb_hw_ep Tony Lindgren
2007-08-13 13:58 ` (no subject) Felipe Balbi
2007-08-14 8:06 ` musb CaMeLcAsEnOmOre (was: (no subject)) David Brownell
2007-08-14 8:55 ` Tony Lindgren
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=11870130521115-git-send-email-tony@atomide.com \
--to=tony@atomide.com \
--cc=linux-omap-open-source@linux.omap.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox