From: Tomi Valkeinen <tomi.valkeinen@nokia.com>
To: "linux-omap@vger.kernel.org" <linux-omap@vger.kernel.org>
Subject: OMAP 3430SDP i2c boot crash
Date: Fri, 16 Apr 2010 11:21:27 +0300 [thread overview]
Message-ID: <1271406087.2690.286.camel@tubuntu.research.nokia.com> (raw)
Hi,
I haven't been able to boot my OMAP 3430SDP board with mainstream kernel
for a while, with the omap_3430sdp_defconfig. Anyone else having
problems? I don't get anything on the console after "Uncompressing
Linux... done, booting the kernel.", and Trace32 shows the log below.
Tomi
___address________|0123456789ABCDEF0123456789ABCDEF0123456789ABCDEF0123456789ABCDEF0123456789ABCDEF0123456789ABCDEF0123456789ABCDEF0123456789ABCDEF
SD:0000:C0424B00 |hsusb2_clk 0x1700 -> 0x0003.<7>mux: Setting signal etk_d12.hsusb2_dir 0x1700 -> 0x010b.<7>mux: Setting signal etk_d13.hsusb2_nxt
SD:0000:C0424B80 | 0x1700 -> 0x010b.<7>mux: Setting signal etk_d14.hsusb2_data0 0x1700 -> 0x010b.<7>mux: Setting signal etk_d15.hsusb2_data1 0x170
SD:0000:C0424C00 |0 -> 0x010b.<7>mux: Setting signal mcspi1_cs3.hsusb2_data2 0x1708 -> 0x010b.<7>mux: Setting signal mcspi2_cs1.hsusb2_data3 0x170
SD:0000:C0424C80 |8 -> 0x010b.<7>mux: Setting signal mcspi2_simo.hsusb2_data4 0x1700 -> 0x010b.<7>mux: Setting signal mcspi2_somi.hsusb2_data5 0x1
SD:0000:C0424D00 |700 -> 0x010b.<7>mux: Setting signal mcspi2_cs0.hsusb2_data6 0x1708 -> 0x010b.<7>mux: Setting signal mcspi2_clk.hsusb2_data7 0x1
SD:0000:C0424D80 |700 -> 0x010b.<6>OMAP DMA hardware revision 4.0.<4>bio: create slab <bio-0> at 0.<5>SCSI subsystem initialized.<6>usbcore: regis
SD:0000:C0424E00 |tered new interface driver usbfs.<6>usbcore: registered new interface driver hub.<6>usbcore: registered new device driver usb.<1
SD:0000:C0424E80 |>Unhandled fault: alignment exception (0x801) at 0xfa070009.<0>Internal error: : 801 [#1].<0>last sysfs file: .<4>Modules linked
SD:0000:C0424F00 | in:.<4>CPU: 0 Not tainted (2.6.34-rc4-00014-g7591eef #937).<4>PC is at omap_i2c_unidle+0x4c/0x140.<4>LR is at omap2_dflt_cl
SD:0000:C0424F80 |k_enable+0xd8/0xe8.<4>pc : [<c024b8e8>] lr : [<c0041ca4>] psr: 60000013.<4>sp : c7c19e60 ip : 00000009 fp : c7c19e74.<4>
SD:0000:C0425000 |r10: 00000000 r9 : 00000000 r8 : c03fa908.<4>r7 : c03fac48 r6 : c03fa900 r5 : c7ca0e00 r4 : c7ca0e00.<4>r3 : 00000009 r2 :
SD:0000:C0425080 | fa070000 r1 : 00000000 r0 : 00000000.<4>Flags: nZCv IRQs on FIQs on Mode SVC_32 ISA ARM Segment kernel.<4>Control: 10c53
SD:0000:C0425100 |87f Table: 80004019 DAC: 00000017.<0>Process swapper (pid: 1, stack limit = 0xc7c182e8).<0>Stack: (0xc7c19e60 to 0xc7c1a000).<
SD:0000:C0425180 |0>9e60: c03f521c c7ca0e00 c7c19eac c7c19e78 c02f7e9c c024b8a8 00000000 c0416110.<0>9e80: c7c19e9c c7c19e90 c00fe430 c03fa908 c03
SD:0000:C0425200 |fa908 c041bac0 c7ca3cc0 c0416110.<0>9ea0: c7c19ebc c7c19eb0 c01e8d60 c02f7cf8 c7c19edc c7c19ec0 c01e7d38 c01e8d4c.<0>9ec0: c03fa
SD:0000:C0425280 |908 c03fa93c c041bac0 c7ca3cc0 c7c19efc c7c19ee0 c01e7e58 c01e7c7c.<0>9ee0: 00000000 c01e7df0 c041bac0 c7ca3cc0 c7c19f24 c7c19f0
SD:0000:C0425300 |0 c01e7514 c01e7dfc.<0>9f00: c7c04af8 c7c445f0 c0194238 c0026ba4 c041bac0 c041bac0 c7c19f34 c7c19f28.<0>9f20: c01e7b84 c01e74d0
SD:0000:C0425380 |c7c19f64 c7c19f38 c01e6df4 c01e7b70 c03c051a 00000000.<0>9f40: c0026ba4 00000000 c041bac0 00000000 00000000 00000000 c7c19f8c c7
SD:0000:C0425400 |c19f68.<0>9f60: c01e8194 c01e6d58 c0026ba4 00000000 c0020018 00000000 00000000 00000000.<0>9f80: c7c19f9c c7c19f90 c01e9204 c01e
SD:0000:C0425480 |80f0 c7c19fac c7c19fa0 c002002c c01e91c4.<0>9fa0: c7c19fdc c7c19fb0 c0031374 c0020024 00000000 00000000 c7c19fdc c7c19fc8.<0>9fc
SD:0000:C0425500 |0: c0026ba4 00000000 00000000 00000000 c7c19ff4 c7c19fe0 c00085f4 c003131c.<0>9fe0: 00000000 00000000 00000000 c7c19ff8 c0060304
SD:0000:C0425580 | c0008568 28050809 01004804.<4>Backtrace: .<4>[<c024b89c>] (omap_i2c_unidle+0x0/0x140) from [<c02f7e9c>] (omap_i2c_probe+0x1b0/0
SD:0000:C0425600 |x3a4).<4> r5:c7ca0e00 r4:c03f521c.<4>[<c02f7cec>] (omap_i2c_probe+0x0/0x3a4) from [<c01e8d60>] (platform_drv_probe+0x20/0x24).<4
SD:0000:C0425680 |> r8:c0416110 r7:c7ca3cc0 r6:c041bac0 r5:c03fa908 r4:c03fa908.<4>[<c01e8d40>] (platform_drv_probe+0x0/0x24) from [<c01e7d38>] (d
SD:0000:C0425700 |river_probe_device+0xc8/0x180).<4>[<c01e7c70>] (driver_probe_device+0x0/0x180) from [<c01e7e58>] (__driver_attach+0x68/0x8c).<4>
SD:0000:C0425780 | r7:c7ca3cc0 r6:c041bac0 r5:c03fa93c r4:c03fa908.<4>[<c01e7df0>] (__driver_attach+0x0/0x8c) from [<c01e7514>] (bus_for_each_dev+
SD:0000:C0425800 |0x50/0x84).<4> r7:c7ca3cc0 r6:c041bac0 r5:c01e7df0 r4:00000000.<4>[<c01e74c4>] (bus_for_each_dev+0x0/0x84) from [<c01e7b84>] (dr
SD:0000:C0425880 |iver_attach+0x20/0x28).<4> r6:c041bac0 r5:c041bac0 r4:c0026ba4.<4>[<c01e7b64>] (driver_attach+0x0/0x28) from [<c01e6df4>] (bus_a
SD:0000:C0425900 |dd_driver+0xa8/0x230).<4>[<c01e6d4c>] (bus_add_driver+0x0/0x230) from [<c01e8194>] (driver_register+0xb0/0x138).<4>[<c01e80e4>]
SD:0000:C0425980 |(driver_register+0x0/0x138) from [<c01e9204>] (platform_driver_register+0x4c/0x60).<4> r9:00000000 r8:00000000 r7:00000000 r6:c0
SD:0000:C0425A00 |020018 r5:00000000.<4>r4:c0026ba4.<4>[<c01e91b8>] (platform_driver_register+0x0/0x60) from [<c002002c>] (omap_i2c_init_driver+0x
SD:0000:C0425A80 |14/0x1c).<4>[<c0020018>] (omap_i2c_init_driver+0x0/0x1c) from [<c0031374>] (do_one_initcall+0x64/0x1bc).<4>[<c0031310>] (do_one_
SD:0000:C0425B00 |initcall+0x0/0x1bc) from [<c00085f4>] (kernel_init+0x98/0x14c).<4> r7:00000000 r6:00000000 r5:00000000 r4:c0026ba4.<4>[<c000855c
SD:0000:C0425B80 |>] (kernel_init+0x0/0x14c) from [<c0060304>] (do_exit+0x0/0x59c).<4> r5:00000000 r4:00000000.<0>Code: e5942004 e3a0c009 e1a0331c
SD:0000:C0425C00 | e3a01000 (e18210b3) .<4>---[ end trace 1b75b31a2719ed1c ]---.<0>Kernel panic - not syncing: Attempted to kill init!............
SD:0000:C0425C80 |................................................................................................................................
SD:0000:C0425D00 |................................................................................................................................
SD:0000:C0425D80 |................................................................................................................................
SD:0000:C0425E00 |................................................................................................................................
SD:0000:C0425E80 |................................................................................................................................
SD:0000:C0425F00 |................................................................................................................................
SD:0000:C0425F80 |................................................................................................................................
SD:0000:C0426000 |................................................................................................................................
SD:0000:C0426080 |................................................................................................................................
SD:0000:C0426100 |................................................................................................................................
SD:0000:C0426180 |................................................................................................................................
SD:0000:C0426200 |................................................................................................................................
next reply other threads:[~2010-04-16 8:21 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2010-04-16 8:21 Tomi Valkeinen [this message]
2010-04-16 8:58 ` OMAP 3430SDP i2c boot crash Mika Westerberg
2010-04-16 11:07 ` Nahamo
2010-04-16 19:31 ` Grazvydas Ignotas
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1271406087.2690.286.camel@tubuntu.research.nokia.com \
--to=tomi.valkeinen@nokia.com \
--cc=linux-omap@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox