[PATCHv2 1/2] OMAP3: Devkit8000: Change lcd power pin

Thomas Weber
2011-01-17T14:12:26Z

The reset_gpio pin for lcd is connected with TWL4030 LedA.
TWL4030 GPIO.1 has a not connected resistor.

Fix indention issue. The comment line uses 8 whitespaces.
Replaced with one tabulator.

Reported-by: Daniel Morsing <daniel.morsing@gmail.com>
Signed-off-by: Thomas Weber <weber@corscience.de>
---
arch/arm/mach-omap2/board-devkit8000.c | 7 ++-----
1 files changed, 2 insertions(+), 5 deletions(-)

diff --git a/arch/arm/mach-omap2/board-devkit8000.c b/arch/arm/mach-omap2/board-devkit8000.c
index 451e7ff..719f4e5 100644
--- a/arch/arm/mach-omap2/board-devkit8000.c
+++ b/arch/arm/mach-omap2/board-devkit8000.c
@@ -114,9 +114,6 @@ static struct omap2_hsmmc_info mmc[] = {

static int devkit8000_panel_enable_lcd(struct omap_dss_device *dssdev)
{
- twl_i2c_write_u8(TWL4030_MODULE_GPIO, 0x80, REG_GPIODATADIR1);
- twl_i2c_write_u8(TWL4030_MODULE_LED, 0x0, 0x0);
-
if (gpio_is_valid(dssdev->reset_gpio))
gpio_set_value_cansleep(dssdev->reset_gpio, 1);
return 0;
@@ -245,8 +242,8 @@ static int devkit8000_twl_gpio_setup(struct device *dev,
/* TWL4030_GPIO_MAX + 1 == ledB, PMU_STAT (out, active low LED) */
gpio_leds[2].gpio = gpio + TWL4030_GPIO_MAX + 1;

- /* gpio + 1 is "LCD_PWREN" (out, active high) */
- devkit8000_lcd_device.reset_gpio = gpio + 1;
+ /* TWL4030_GPIO_MAX + 0 is "LCD_PWREN" (out, active high) */
+ devkit8000_lcd_device.reset_gpio = gpio + TWL4030_GPIO_MAX + 0;
gpio_request(devkit8000_lcd_device.reset_gpio, "LCD_PWREN");
/* Disable until needed */
gpio_direction_output(devkit8000_lcd_device.reset_gpio, 0);
--
1.7.4.rc2