Re: [PATCH v12 1/1] serial: core: Start managing serial controllers to enable runtime PM

[Maximilian Luz <luzmaximilian@gmail.com>]

On 10/4/23 12:01, Tony Lindgren wrote:
> * Johan Hovold <johan@kernel.org> [231004 09:14]:
>> On Wed, Oct 04, 2023 at 12:03:20PM +0300, Tony Lindgren wrote:
>>> The serial port device and serdev device are siblings of the physical
>>> serial port controller device as seen in the hierarcy printed out by
>>> Maximilian.
>>
>> Yeah, and that's precisely the broken part. Keeping the serdev
>> controller active is supposed to keep the serial controller active. Your
>> serial core rework appears to have broken just that.
> 
> Hmm OK good point, tx can currently have an extra delay if a serdev
> device is active, and the serial port controller device is not active.
> 
> So we can check for active port->dev instead of &port_dev->dev though
> to know when when start_tx() is safe to do as below.

I can confirm that this works as well.

Thanks,
Max

> 8< -----------------
> diff --git a/drivers/tty/serial/serial_core.c b/drivers/tty/serial/serial_core.c
> index 6207f0051f23d..defecc5b04422 100644
> --- a/drivers/tty/serial/serial_core.c
> +++ b/drivers/tty/serial/serial_core.c
> @@ -156,7 +156,7 @@ static void __uart_start(struct uart_state *state)
>   	 * enabled, serial_port_runtime_resume() calls start_tx() again
>   	 * after enabling the device.
>   	 */
> -	if (pm_runtime_active(&port_dev->dev))
> +	if (!pm_runtime_enabled(port->dev) || pm_runtime_active(port->dev))
>   		port->ops->start_tx(port);
>   	pm_runtime_mark_last_busy(&port_dev->dev);
>   	pm_runtime_put_autosuspend(&port_dev->dev);
>