Re: OSK5912 and CF and network broken?

[tony@atomide.com]

* Tom Rini <trini@kernel.crashing.org> [060316 09:20]:
> On Thu, Mar 16, 2006 at 06:03:02PM +0100, Dirk Behme wrote:
> > Tom Rini wrote:
> > >Has anyone seen this before?  Or should I just looking at the interrupt
> > >routes?  I'm assuming that the board does support me using both CF and
> > >network at the same time.  Thanks!
> > 
> > Yes, board supports both, CF and network. However, OSK CF 
> > hardware is limited and is really troublesome.
> 
> I wonder if my board is just more troublesome than most.  If I turned off
> network (and used a ramdisk for userspace) I then got to the point of:
> 
> pccard: PCMCIA card inserted into slot 0                                      
> pcmcia: registering new device pcmcia0.0                                        
> hdb: probing with STATUS(0x00) instead of ALTSTATUS(0x51)                       
> hdb: probing with STATUS(0x00) instead of ALTSTATUS(0x51)                       
> hdb: probing with STATUS(0x00) instead of ALTSTATUS(0x51)                       
> hdb: probing with STATUS(0x00) instead of ALTSTATUS(0x51)                       
> hdb: probing with STATUS(0x00) instead of ALTSTATUS(0x51)                       
> hdb: probing with STATUS(0x00) instead of ALTSTATUS(0x51)                       
> hdb: probing with STATUS(0x00) instead of ALTSTATUS(0x51)                       
> hdb: probing with STATUS(0x00) instead of ALTSTATUS(0x51)                       
> hdb: probing with STATUS(0x00) instead of ALTSTATUS(0x51)                       
> hdb: probing with STATUS(0x00) instead of ALTSTATUS(0x51)                       
> ide-cs: ide_register() at 0xc2852000 & 0xc285200e, irq 222 failed
> 
> with an old 16MB CF card.  With my 2.2GB microdrive I get more of the
> messages, but the same result.  FWIW, u-boot won't load if the MD is
> inserted, but will if the CF is.
> 
> But perhaps I need a better cardmgr options file?  I don't have anything
> board-specific in mine.  Thanks!

I believe there may be some different timings needed depending on the
OSK revision.

Tony