Re: RMKs comments on latest OMAP upstream patches

Tony Lindgren
2007-09-23T21:21:49Z

* Woodruff, Richard <r-woodruff2@ti.com> [070921 01:31]:
> > > OMAP1:
> > > http://www.arm.linux.org.uk/developer/patches/viewpatch.php?id=4570/1
> > >
> > > OMAP2:
> > > http://www.arm.linux.org.uk/developer/patches/viewpatch.php?id=4571/1

Looks like Russell has applied these two patch series above!

> Hum, I should Russell's comment reference. Yes there is a clock register function, however, there is no, command to create a new node. Further you are not supposed to know what the node structure is. In the TI tree variant I did add a node create and destroy function. However, it does cheat and exports some parameters which imply internal knowledge of the clock structure.
>
> It would seem the best you could do was to pre-install some dummy nodes. However, you still need a way to fill in the function pointers... Again, need check his pointer.

For board specific GPIO clock control clk_register() with custom
enable/disable functions should work just fine though.

Tony