* OMAP2430 RESET STANDBY GPIO can not set
@ 2007-11-23 14:07 shanghai
0 siblings, 0 replies; only message in thread
From: shanghai @ 2007-11-23 14:07 UTC (permalink / raw)
To: linux-omap-open-source, linux-omap
Hi:
I am working on omap2430sdp for developing camera driver.But I found I can
not operate the GPIO: STANDBY and RESET pin when I pull it high or set it low?I am
using kernel2.6.14 and dip S4-S10 setting like this:
S10
1 2 3 4
ON ON ON ON
S9
1 2 3 4 5 6 7 8
ON ON ON ON ON ON ON OFF
S8
1 2 3 4 5 6 7 8
ON ON ON ON ON ON ON OFF
S6
1 2 3 4 5 6 7 8
ON ON OFF OFF OFF OFF OFF ON
S4
1 2 3 4 5 6 7 8
OFF OFF OFF OFF ON ON OFF OFF
should I change the DIP state to enable the camera interface or somewhere in kernel
need check?
any suggestion are welcome!
--
Open WebMail Project (http://openwebmail.org)
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2007-11-23 14:07 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2007-11-23 14:07 OMAP2430 RESET STANDBY GPIO can not set shanghai
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox