From mboxrd@z Thu Jan 1 00:00:00 1970 From: "shanghai" Subject: OMAP2430 RESET STANDBY GPIO can not set Date: Fri, 23 Nov 2007 22:07:38 +0800 Message-ID: <20071123140541.M90782@ovt.com.cn> Mime-Version: 1.0 Content-Type: text/plain; charset=gb2312 Return-path: List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Sender: linux-omap-open-source-bounces@linux.omap.com Errors-To: linux-omap-open-source-bounces@linux.omap.com To: linux-omap-open-source@linux.omap.com, linux-omap@vger.kernel.org List-Id: linux-omap@vger.kernel.org Hi: I am working on omap2430sdp for developing camera driver.But I found I can not operate the GPIO: STANDBY and RESET pin when I pull it high or set it low?I am using kernel2.6.14 and dip S4-S10 setting like this: S10 1 2 3 4 ON ON ON ON S9 1 2 3 4 5 6 7 8 ON ON ON ON ON ON ON OFF S8 1 2 3 4 5 6 7 8 ON ON ON ON ON ON ON OFF S6 1 2 3 4 5 6 7 8 ON ON OFF OFF OFF OFF OFF ON S4 1 2 3 4 5 6 7 8 OFF OFF OFF OFF ON ON OFF OFF should I change the DIP state to enable the camera interface or somewhere in kernel need check? any suggestion are welcome! -- Open WebMail Project (http://openwebmail.org)