Re: N810: linux-2.6.26-rc2-omap1 with muru.com N810 patches

[green <greenfreedom10@gmail.com>]

[-- Attachment #1: Type: text/plain, Size: 1391 bytes --]

On Thu, 2008.05.15, 136, Felipe Balbi wrote:
> > Always, one of these two happens after I flash the compiled zImage:
> >  - The NOKIA splash screen is displayed for about 20 seconds and then the
> > N810 
> > powers off.
> >  - The splash screen is shown for <1 second and the device resets (loop);
> > I 
> > have to remove the battery.
> 
> flasher --enable-rd-mode --set-rd-flags=serial-console,no-lifeguard-reset
> -f

I had already done that, though not the serial-console one; I don't have any 
way to use it:

> > I have enable R&D mode on the N810 and disabled the lifeguard-reset flag.

> > I've used 'make n800_defconfig' (2.6.26-rc2-omap1 +N810) and changed only
> > the 
> > default cmdline without success.  Also I've used 'make
> > nokia_2420_defconfig' 
> > with the maemo kernel.
> 
> try also
> flasher --set-root-device mmc

I've tried this before, but can it really make any difference to whether the 
custom kernel boots?  The root device doesn't matter until after I have 
successfully booted a kernel.

> > Oh, and one more question that I ought to know the answer to by now:
> > Is it okay to do 'make zImage', then change the config, then 'make
> zImage'
> > 
> > again without doing a 'make clean', so long as nothing in the source has
> > been 
> > changed?  That saves a lot of time.
> 
> Yes, it's ok. ;-)

Great, thanks!

[-- Attachment #2: Digital signature --]
[-- Type: application/pgp-signature, Size: 189 bytes --]