linux-omap.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Ben Dooks <ben-linux@fluff.org>
To: Tony Lindgren <tony@atomide.com>
Cc: i2c@lm-sensors.org, Paul Walmsley <paul@pwsan.com>,
	linux-omap@vger.kernel.org
Subject: Re: [i2c] [PATCH 2/8] i2c-omap: Close suspected race between omap_i2c_idle() and omap_i2c_isr()
Date: Mon, 29 Sep 2008 23:21:47 +0100	[thread overview]
Message-ID: <20080929222147.GO2716@fluff.org.uk> (raw)
In-Reply-To: <1222329234-31473-3-git-send-email-tony@atomide.com>

On Thu, Sep 25, 2008 at 10:53:48AM +0300, Tony Lindgren wrote:
> From: Paul Walmsley <paul@pwsan.com>
> 
> omap_i2c_idle() sets an internal flag, "dev->idle", instructing its
> ISR to decline interrupts.  It sets this flag before it actually masks
> the interrupts on the I2C controller.  This is problematic, since an
> I2C interrupt could arrive after dev->idle is set, but before the
> interrupt source is masked.  When this happens, Linux disables the I2C
> controller's IRQ, causing all future transactions on the bus to fail.
> 
> Symptoms, happening on about 7% of boots:
> 
>    irq 56: nobody cared (try booting with the "irqpoll" option)
>    <warning traceback here>
>    Disabling IRQ #56
>    i2c_omap i2c_omap.1: controller timed out
> 
> In omap_i2c_idle(), this patch sets dev->idle only after the interrupt
> mask write to the I2C controller has left the ARM write buffer.
> That's probably the major offender.  For additional prophylaxis, in
> omap_i2c_unidle(), the patch clears the dev->idle flag before
> interrupts are enabled, rather than afterwards.
> 
> The patch has survived twenty-two reboots on the 3430SDP here without
> wedging I2C1.  Not absolutely dispositive, but promising!

that looks ok.
 
> Signed-off-by: Paul Walmsley <paul@pwsan.com>
> Signed-off-by: Tony Lindgren <tony@atomide.com>
> ---
>  drivers/i2c/busses/i2c-omap.c |   10 ++++++++--
>  1 files changed, 8 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/i2c/busses/i2c-omap.c b/drivers/i2c/busses/i2c-omap.c
> index cfb76f5..a06ad42 100644
> --- a/drivers/i2c/busses/i2c-omap.c
> +++ b/drivers/i2c/busses/i2c-omap.c
> @@ -181,22 +181,28 @@ static void omap_i2c_unidle(struct omap_i2c_dev *dev)
>  	if (dev->iclk != NULL)
>  		clk_enable(dev->iclk);
>  	clk_enable(dev->fclk);
> +	dev->idle = 0;
>  	if (dev->iestate)
>  		omap_i2c_write_reg(dev, OMAP_I2C_IE_REG, dev->iestate);
> -	dev->idle = 0;
>  }
>  
>  static void omap_i2c_idle(struct omap_i2c_dev *dev)
>  {
>  	u16 iv;
>  
> -	dev->idle = 1;
>  	dev->iestate = omap_i2c_read_reg(dev, OMAP_I2C_IE_REG);
>  	omap_i2c_write_reg(dev, OMAP_I2C_IE_REG, 0);
>  	if (dev->rev1)
>  		iv = omap_i2c_read_reg(dev, OMAP_I2C_IV_REG);	/* Read clears */
>  	else
>  		omap_i2c_write_reg(dev, OMAP_I2C_STAT_REG, dev->iestate);
> +	/*
> +	 * The wmb() is to ensure that the I2C interrupt mask write
> +	 * reaches the I2C controller before the dev->idle store
> +	 * occurs.
> +	 */
> +	wmb();
> +	dev->idle = 1;
>  	clk_disable(dev->fclk);
>  	if (dev->iclk != NULL)
>  		clk_disable(dev->iclk);
> -- 
> 1.5.6.rc3.21.g8c6b5
> 
> 
> _______________________________________________
> i2c mailing list
> i2c@lm-sensors.org
> http://lists.lm-sensors.org/mailman/listinfo/i2c

-- 
Ben (ben@fluff.org, http://www.fluff.org/)

  'a smiley only costs 4 bytes'

  parent reply	other threads:[~2008-09-29 22:22 UTC|newest]

Thread overview: 33+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2008-09-25  7:53 [PATCH 0/8] Updates for i2c-omap from linux-omap tree for review, v2 Tony Lindgren
2008-09-25  7:53 ` [PATCH 1/8] i2c-omap: Do not use interruptible wait call in omap_i2c_xfer_msg Tony Lindgren
2008-09-25  7:53   ` [PATCH 2/8] i2c-omap: Close suspected race between omap_i2c_idle() and omap_i2c_isr() Tony Lindgren
2008-09-25  7:53     ` [PATCH 3/8] i2c-omap: Add high-speed support to omap-i2c Tony Lindgren
2008-09-25  7:53       ` [PATCH 4/8] i2c-omap: FIFO handling support and broken hw workaround for i2c-omap Tony Lindgren
2008-09-25  7:53         ` [PATCH 5/8] i2c-omap: Add support on 34xx Tony Lindgren
2008-09-25  7:53           ` [PATCH 6/8] i2c-omap: Mark init-only functions as __init Tony Lindgren
2008-09-25  7:53             ` [PATCH 7/8] i2c-omap: Don't compile in OMAP15xx I2C ISR for non-OMAP15xx builds Tony Lindgren
2008-09-25  7:53               ` [PATCH 8/8] i2c-omap: Clean-up i2c-omap Tony Lindgren
2008-09-25 11:40                 ` [PATCH 8/8] i2c-omap: Clean-up i2c-omap, v3 Tony Lindgren
2008-09-29 22:31                 ` [i2c] [PATCH 8/8] i2c-omap: Clean-up i2c-omap Ben Dooks
2008-10-17 15:41                   ` Tony Lindgren
2008-09-29 22:29               ` [i2c] [PATCH 7/8] i2c-omap: Don't compile in OMAP15xx I2C ISR for non-OMAP15xx builds Ben Dooks
2008-09-29 23:06                 ` David Brownell
2008-09-30  5:35                   ` Paul Walmsley
2008-09-30  5:36                     ` Paul Walmsley
2008-10-17 15:40                       ` Tony Lindgren
2008-09-29 22:30             ` [i2c] [PATCH 6/8] i2c-omap: Mark init-only functions as __init Ben Dooks
2008-10-17 15:39               ` Tony Lindgren
2008-10-17 17:07                 ` Tony Lindgren
2008-09-29 22:28           ` [i2c] [PATCH 5/8] i2c-omap: Add support on 34xx Ben Dooks
2008-10-17 15:38             ` Tony Lindgren
2008-09-25 11:39         ` [PATCH 4/8] i2c-omap: FIFO handling support and broken hw workaround for i2c-omap, v3 Tony Lindgren
2008-09-29 22:27         ` [i2c] [PATCH 4/8] i2c-omap: FIFO handling support and broken hw workaround for i2c-omap Ben Dooks
2008-09-29 22:25       ` [i2c] [PATCH 3/8] i2c-omap: Add high-speed support to omap-i2c Ben Dooks
2008-10-17 15:37         ` Tony Lindgren
2008-09-29 22:21     ` Ben Dooks [this message]
2008-09-29 22:21   ` [i2c] [PATCH 1/8] i2c-omap: Do not use interruptible wait call in omap_i2c_xfer_msg Ben Dooks
2008-09-30 11:51     ` Jarkko Nikula
2008-10-17 15:35       ` Tony Lindgren
2008-09-29 22:23 ` [i2c] [PATCH 0/8] Updates for i2c-omap from linux-omap tree for review, v2 Ben Dooks
2008-09-30  5:35   ` Tony Lindgren
2008-10-17 16:04     ` git-pull request for i2c-omap changes (Re: [i2c] [PATCH 0/8] Updates for i2c-omap from linux-omap tree for review, v2) Tony Lindgren

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20080929222147.GO2716@fluff.org.uk \
    --to=ben-linux@fluff.org \
    --cc=i2c@lm-sensors.org \
    --cc=linux-omap@vger.kernel.org \
    --cc=paul@pwsan.com \
    --cc=tony@atomide.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).