[PATCH v2] omap2: ehci: Make Overo compile again

[Olof Johansson <olof@lixom.net>]

Overo needs the same changes as the other platforms do for the ehci changes.

Also, roll in the corresponding change from Steve Sakoman fixing the
port setup (removing the redundant GPIO setup and switching to port 2).

Signed-off-by: Olof Johansson <olof@lixom.net>

---

diff --git a/arch/arm/mach-omap2/board-overo.c b/arch/arm/mach-omap2/board-overo.c
index 17f2318..75bdc09 100644
--- a/arch/arm/mach-omap2/board-overo.c
+++ b/arch/arm/mach-omap2/board-overo.c
@@ -384,6 +384,19 @@ static struct platform_device *overo_devices[] __initdata = {
 	&overo_lcd_device,
 };
 
+static struct ehci_hcd_omap_platform_data ehci_pdata __initconst = {
+	.port_mode[0] = EHCI_HCD_OMAP_MODE_UNKNOWN,
+	.port_mode[1] = EHCI_HCD_OMAP_MODE_PHY,
+	.port_mode[2] = EHCI_HCD_OMAP_MODE_UNKNOWN,
+
+	.chargepump = false,
+	.phy_reset  = true,
+	.reset_gpio_port[0]  = -EINVAL,
+	.reset_gpio_port[1]  = OVERO_GPIO_USBH_NRESET,
+	.reset_gpio_port[2]  = -EINVAL
+};
+
+
 static void __init overo_init(void)
 {
 	overo_i2c_init();
@@ -391,7 +404,7 @@ static void __init overo_init(void)
 	omap_serial_init();
 	overo_flash_init();
 	usb_musb_init();
-	usb_ehci_init(EHCI_HCD_OMAP_MODE_PHY, false, true, 183, -EINVAL);
+	usb_ehci_init(&ehci_pdata);
 	overo_ads7846_init();
 	overo_init_smsc911x();
 
@@ -434,14 +447,6 @@ static void __init overo_init(void)
 	else
 		printk(KERN_ERR "could not obtain gpio for "
 					"OVERO_GPIO_USBH_CPEN\n");
-
-	if ((gpio_request(OVERO_GPIO_USBH_NRESET,
-			  "OVERO_GPIO_USBH_NRESET") == 0) &&
-	    (gpio_direction_output(OVERO_GPIO_USBH_NRESET, 1) == 0))
-		gpio_export(OVERO_GPIO_USBH_NRESET, 0);
-	else
-		printk(KERN_ERR "could not obtain gpio for "
-					"OVERO_GPIO_USBH_NRESET\n");
 }
 
 static void __init overo_map_io(void)