From: Tony Lindgren <tony@atomide.com>
To: Kevin Hilman <khilman@deeprootsystems.com>
Cc: "Mark A. Greer" <mgreer@mvista.com>,
rtc-linux@googlegroups.com, David Brownell <david-b@pacbell.net>,
linux-omap@vger.kernel.org,
Davinci-linux-open-source@linux.davincidsp.com
Subject: Re: [PATCH v2] rtc: make rtc-omap driver ioremap its register space
Date: Tue, 22 Sep 2009 15:00:56 -0700 [thread overview]
Message-ID: <20090922220056.GG4919@atomide.com> (raw)
In-Reply-To: <87d45ievqa.fsf@deeprootsystems.com>
* Kevin Hilman <khilman@deeprootsystems.com> [090922 10:27]:
> "Mark A. Greer" <mgreer@mvista.com> writes:
>
> > From: Mark A. Greer <mgreer@mvista.com>
> >
> > The rtc-omap driver currently assumes that the rtc's
> > registers are at a fixed address and already mapped
> > into virtual memory space. Remove those assumptions
> > so the same driver can be used for similar devices
> > that reside at different physical addresses (e.g.,
> > TI's DA8xx/OMAP-L13x SoC's).
> >
> > Also allow the possibility for the timer and alarm
> > interrupts to use the same IRQ.
> >
> > Signed-off-by: Mark A. Greer <mgreer@mvista.com>
> > CC: David Brownell <david-b@pacbell.net>
>
> Acked-by: Kevin Hilman <khilman@deeprootsystems.com>
>
> for relevance to davinci platforms.
Acked-by: Tony Lindgren <tony@atomide.com>
>
> Kevin
>
>
> > ---
> > Sorry for the cross-posting but this is relevant to the different lists.
> >
> > This patch was tested on a da830 and a da850. It was only compiled
> > for an omap1 platform (don't have the hardware) but it should be low
> > risk. Note that the platform_device data is already set up in
> > arch/arm/mach-omap1/devices.c so it those platforms should
> > "Just Work(tm)".
> >
> > drivers/rtc/Kconfig | 7 ++++---
> > drivers/rtc/rtc-omap.c | 47 ++++++++++++++++++++++++++---------------------
> > 2 files changed, 30 insertions(+), 24 deletions(-)
> >
> > diff --git a/drivers/rtc/Kconfig b/drivers/rtc/Kconfig
> > index 81adbdb..f06e885 100644
> > --- a/drivers/rtc/Kconfig
> > +++ b/drivers/rtc/Kconfig
> > @@ -539,10 +539,11 @@ comment "on-CPU RTC drivers"
> >
> > config RTC_DRV_OMAP
> > tristate "TI OMAP1"
> > - depends on ARCH_OMAP15XX || ARCH_OMAP16XX || ARCH_OMAP730
> > + depends on ARCH_OMAP15XX || ARCH_OMAP16XX || ARCH_OMAP730 || ARCH_DAVINCI_DA8XX
> > help
> > - Say "yes" here to support the real time clock on TI OMAP1 chips.
> > - This driver can also be built as a module called rtc-omap.
> > + Say "yes" here to support the real time clock on TI OMAP1 and
> > + DA8xx/OMAP-L13x chips. This driver can also be built as a
> > + module called rtc-omap.
> >
> > config RTC_DRV_S3C
> > tristate "Samsung S3C series SoC RTC"
> > diff --git a/drivers/rtc/rtc-omap.c b/drivers/rtc/rtc-omap.c
> > index bd1ce8e..aa418d5 100644
> > --- a/drivers/rtc/rtc-omap.c
> > +++ b/drivers/rtc/rtc-omap.c
> > @@ -87,9 +87,10 @@
> > #define OMAP_RTC_INTERRUPTS_IT_ALARM (1<<3)
> > #define OMAP_RTC_INTERRUPTS_IT_TIMER (1<<2)
> >
> > +static void __iomem *rtc_base;
> >
> > -#define rtc_read(addr) omap_readb(OMAP_RTC_BASE + (addr))
> > -#define rtc_write(val, addr) omap_writeb(val, OMAP_RTC_BASE + (addr))
> > +#define rtc_read(addr) __raw_readb(rtc_base + (addr))
> > +#define rtc_write(val, addr) __raw_writeb(val, rtc_base + (addr))
> >
> >
> > /* we rely on the rtc framework to handle locking (rtc->ops_lock),
> > @@ -330,32 +331,31 @@ static int __init omap_rtc_probe(struct platform_device *pdev)
> > return -ENOENT;
> > }
> >
> > - /* NOTE: using static mapping for RTC registers */
> > res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> > - if (res && res->start != OMAP_RTC_BASE) {
> > - pr_debug("%s: RTC registers at %08x, expected %08x\n",
> > - pdev->name, (unsigned) res->start, OMAP_RTC_BASE);
> > + if (!res) {
> > + pr_debug("%s: RTC resource data missing\n", pdev->name);
> > return -ENOENT;
> > }
> >
> > - if (res)
> > - mem = request_mem_region(res->start,
> > - res->end - res->start + 1,
> > - pdev->name);
> > - else
> > - mem = NULL;
> > + mem = request_mem_region(res->start, resource_size(res), pdev->name);
> > if (!mem) {
> > pr_debug("%s: RTC registers at %08x are not free\n",
> > - pdev->name, OMAP_RTC_BASE);
> > + pdev->name, res->start);
> > return -EBUSY;
> > }
> >
> > + rtc_base = ioremap(res->start, resource_size(res));
> > + if (!rtc_base) {
> > + pr_debug("%s: RTC registers can't be mapped\n", pdev->name);
> > + goto fail;
> > + }
> > +
> > rtc = rtc_device_register(pdev->name, &pdev->dev,
> > &omap_rtc_ops, THIS_MODULE);
> > if (IS_ERR(rtc)) {
> > pr_debug("%s: can't register RTC device, err %ld\n",
> > pdev->name, PTR_ERR(rtc));
> > - goto fail;
> > + goto fail0;
> > }
> > platform_set_drvdata(pdev, rtc);
> > dev_set_drvdata(&rtc->dev, mem);
> > @@ -380,13 +380,14 @@ static int __init omap_rtc_probe(struct platform_device *pdev)
> > dev_name(&rtc->dev), rtc)) {
> > pr_debug("%s: RTC timer interrupt IRQ%d already claimed\n",
> > pdev->name, omap_rtc_timer);
> > - goto fail0;
> > + goto fail1;
> > }
> > - if (request_irq(omap_rtc_alarm, rtc_irq, IRQF_DISABLED,
> > - dev_name(&rtc->dev), rtc)) {
> > + if ((omap_rtc_timer != omap_rtc_alarm) &&
> > + (request_irq(omap_rtc_alarm, rtc_irq, IRQF_DISABLED,
> > + dev_name(&rtc->dev), rtc))) {
> > pr_debug("%s: RTC alarm interrupt IRQ%d already claimed\n",
> > pdev->name, omap_rtc_alarm);
> > - goto fail1;
> > + goto fail2;
> > }
> >
> > /* On boards with split power, RTC_ON_NOFF won't reset the RTC */
> > @@ -419,10 +420,12 @@ static int __init omap_rtc_probe(struct platform_device *pdev)
> >
> > return 0;
> >
> > -fail1:
> > +fail2:
> > free_irq(omap_rtc_timer, NULL);
> > -fail0:
> > +fail1:
> > rtc_device_unregister(rtc);
> > +fail0:
> > + iounmap(rtc_base);
> > fail:
> > release_resource(mem);
> > return -EIO;
> > @@ -438,7 +441,9 @@ static int __exit omap_rtc_remove(struct platform_device *pdev)
> > rtc_write(0, OMAP_RTC_INTERRUPTS_REG);
> >
> > free_irq(omap_rtc_timer, rtc);
> > - free_irq(omap_rtc_alarm, rtc);
> > +
> > + if (omap_rtc_timer != omap_rtc_alarm)
> > + free_irq(omap_rtc_alarm, rtc);
> >
> > release_resource(dev_get_drvdata(&rtc->dev));
> > rtc_device_unregister(rtc);
> > --
> > 1.6.2.5.182.ga808d
> >
> > --
> > To unsubscribe from this list: send the line "unsubscribe linux-omap" in
> > the body of a message to majordomo@vger.kernel.org
> > More majordomo info at http://vger.kernel.org/majordomo-info.html
> --
> To unsubscribe from this list: send the line "unsubscribe linux-omap" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
next prev parent reply other threads:[~2009-09-22 22:01 UTC|newest]
Thread overview: 6+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-09-17 0:04 [PATCH v2] rtc: make rtc-omap driver ioremap its register space Mark A. Greer
2009-09-22 17:26 ` Kevin Hilman
2009-09-22 22:00 ` Tony Lindgren [this message]
[not found] ` <20090917000458.GA6119-S3yzRvi4kHRa+ipTMWa7OQC/G2K4zDHf@public.gmane.org>
2009-09-17 4:02 ` David Brownell
2009-10-13 23:00 ` Mark A. Greer
2009-10-13 23:15 ` [rtc-linux] " Alessandro Zummo
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20090922220056.GG4919@atomide.com \
--to=tony@atomide.com \
--cc=Davinci-linux-open-source@linux.davincidsp.com \
--cc=david-b@pacbell.net \
--cc=khilman@deeprootsystems.com \
--cc=linux-omap@vger.kernel.org \
--cc=mgreer@mvista.com \
--cc=rtc-linux@googlegroups.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox