From: Felipe Balbi <felipe.balbi@nokia.com>
To: "Balbi Felipe (Nokia-D/Helsinki)" <felipe.balbi@nokia.com>
Cc: "linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>,
Linux OMAP Mailing List <linux-omap@vger.kernel.org>,
Tony Lindgren <tony@atomide.com>,
"Tereshonkov Roman (Nokia-D/Helsinki)"
<roman.tereshonkov@nokia.com>,
Andrew Morton <akpm@linux-foundation.org>,
David Brownell <david-b@pacbell.net>,
Grant Likely <grant.likely@secretlab.ca>
Subject: Re: [PATCH] spi: omap2_mcspi: make use of dev_vdbg()
Date: Mon, 9 Aug 2010 13:36:18 +0300 [thread overview]
Message-ID: <20100809103618.GE11340@nokia.com> (raw)
In-Reply-To: <1275563341-31078-1-git-send-email-felipe.balbi@nokia.com>
On Thu, Jun 03, 2010 at 01:09:01PM +0200, Balbi Felipe (Nokia-D/Helsinki) wrote:
>From: Felipe Balbi <felipe.balbi@nokia.com>
>
>dev_vdbg() is only compiled when VERBOSE is defined, so
>there's no need to wrap dev_dbg() on #ifdef VERBOSE .. #endif
>as we can use dev_vdbg() directly.
>
>Signed-off-by: Felipe Balbi <felipe.balbi@nokia.com>
>---
ping, any comments to this one ? It's been pending for quite a long
time.
> drivers/spi/omap2_mcspi.c | 36 +++++++++---------------------------
> 1 files changed, 9 insertions(+), 27 deletions(-)
>
>diff --git a/drivers/spi/omap2_mcspi.c b/drivers/spi/omap2_mcspi.c
>index b3a94ca..d703927 100644
>--- a/drivers/spi/omap2_mcspi.c
>+++ b/drivers/spi/omap2_mcspi.c
>@@ -489,10 +489,8 @@ omap2_mcspi_txrx_pio(struct spi_device *spi, struct spi_transfer *xfer)
> dev_err(&spi->dev, "TXS timed out\n");
> goto out;
> }
>-#ifdef VERBOSE
>- dev_dbg(&spi->dev, "write-%d %02x\n",
>+ dev_vdbg(&spi->dev, "write-%d %02x\n",
> word_len, *tx);
>-#endif
> __raw_writel(*tx++, tx_reg);
> }
> if (rx != NULL) {
>@@ -506,10 +504,8 @@ omap2_mcspi_txrx_pio(struct spi_device *spi, struct spi_transfer *xfer)
> (l & OMAP2_MCSPI_CHCONF_TURBO)) {
> omap2_mcspi_set_enable(spi, 0);
> *rx++ = __raw_readl(rx_reg);
>-#ifdef VERBOSE
>- dev_dbg(&spi->dev, "read-%d %02x\n",
>+ dev_vdbg(&spi->dev, "read-%d %02x\n",
> word_len, *(rx - 1));
>-#endif
> if (mcspi_wait_for_reg_bit(chstat_reg,
> OMAP2_MCSPI_CHSTAT_RXS) < 0) {
> dev_err(&spi->dev,
>@@ -522,10 +518,8 @@ omap2_mcspi_txrx_pio(struct spi_device *spi, struct spi_transfer *xfer)
> }
>
> *rx++ = __raw_readl(rx_reg);
>-#ifdef VERBOSE
>- dev_dbg(&spi->dev, "read-%d %02x\n",
>+ dev_vdbg(&spi->dev, "read-%d %02x\n",
> word_len, *(rx - 1));
>-#endif
> }
> } while (c);
> } else if (word_len <= 16) {
>@@ -542,10 +536,8 @@ omap2_mcspi_txrx_pio(struct spi_device *spi, struct spi_transfer *xfer)
> dev_err(&spi->dev, "TXS timed out\n");
> goto out;
> }
>-#ifdef VERBOSE
>- dev_dbg(&spi->dev, "write-%d %04x\n",
>+ dev_vdbg(&spi->dev, "write-%d %04x\n",
> word_len, *tx);
>-#endif
> __raw_writel(*tx++, tx_reg);
> }
> if (rx != NULL) {
>@@ -559,10 +551,8 @@ omap2_mcspi_txrx_pio(struct spi_device *spi, struct spi_transfer *xfer)
> (l & OMAP2_MCSPI_CHCONF_TURBO)) {
> omap2_mcspi_set_enable(spi, 0);
> *rx++ = __raw_readl(rx_reg);
>-#ifdef VERBOSE
>- dev_dbg(&spi->dev, "read-%d %04x\n",
>+ dev_vdbg(&spi->dev, "read-%d %04x\n",
> word_len, *(rx - 1));
>-#endif
> if (mcspi_wait_for_reg_bit(chstat_reg,
> OMAP2_MCSPI_CHSTAT_RXS) < 0) {
> dev_err(&spi->dev,
>@@ -575,10 +565,8 @@ omap2_mcspi_txrx_pio(struct spi_device *spi, struct spi_transfer *xfer)
> }
>
> *rx++ = __raw_readl(rx_reg);
>-#ifdef VERBOSE
>- dev_dbg(&spi->dev, "read-%d %04x\n",
>+ dev_vdbg(&spi->dev, "read-%d %04x\n",
> word_len, *(rx - 1));
>-#endif
> }
> } while (c);
> } else if (word_len <= 32) {
>@@ -595,10 +583,8 @@ omap2_mcspi_txrx_pio(struct spi_device *spi, struct spi_transfer *xfer)
> dev_err(&spi->dev, "TXS timed out\n");
> goto out;
> }
>-#ifdef VERBOSE
>- dev_dbg(&spi->dev, "write-%d %08x\n",
>+ dev_vdbg(&spi->dev, "write-%d %08x\n",
> word_len, *tx);
>-#endif
> __raw_writel(*tx++, tx_reg);
> }
> if (rx != NULL) {
>@@ -612,10 +598,8 @@ omap2_mcspi_txrx_pio(struct spi_device *spi, struct spi_transfer *xfer)
> (l & OMAP2_MCSPI_CHCONF_TURBO)) {
> omap2_mcspi_set_enable(spi, 0);
> *rx++ = __raw_readl(rx_reg);
>-#ifdef VERBOSE
>- dev_dbg(&spi->dev, "read-%d %08x\n",
>+ dev_vdbg(&spi->dev, "read-%d %08x\n",
> word_len, *(rx - 1));
>-#endif
> if (mcspi_wait_for_reg_bit(chstat_reg,
> OMAP2_MCSPI_CHSTAT_RXS) < 0) {
> dev_err(&spi->dev,
>@@ -628,10 +612,8 @@ omap2_mcspi_txrx_pio(struct spi_device *spi, struct spi_transfer *xfer)
> }
>
> *rx++ = __raw_readl(rx_reg);
>-#ifdef VERBOSE
>- dev_dbg(&spi->dev, "read-%d %08x\n",
>+ dev_vdbg(&spi->dev, "read-%d %08x\n",
> word_len, *(rx - 1));
>-#endif
> }
> } while (c);
> }
>--
>1.7.1
--
balbi
DefectiveByDesign.org
next prev parent reply other threads:[~2010-08-09 10:36 UTC|newest]
Thread overview: 9+ messages / expand[flat|nested] mbox.gz Atom feed top
2010-06-03 11:09 [PATCH] spi: omap2_mcspi: make use of dev_vdbg() felipe.balbi
2010-08-09 10:36 ` Felipe Balbi [this message]
2010-08-09 13:22 ` Grant Likely
2010-08-10 5:21 ` Felipe Balbi
2010-08-10 5:27 ` Grant Likely
2010-08-10 5:45 ` Felipe Balbi
2010-08-10 6:54 ` David Brownell
2010-08-10 6:33 ` Grant Likely
[not found] ` <20100810063341.GA28597-MrY2KI0G/OVr83L8+7iqerDks+cytr/Z@public.gmane.org>
2010-08-10 6:39 ` Felipe Balbi
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20100809103618.GE11340@nokia.com \
--to=felipe.balbi@nokia.com \
--cc=akpm@linux-foundation.org \
--cc=david-b@pacbell.net \
--cc=grant.likely@secretlab.ca \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-omap@vger.kernel.org \
--cc=roman.tereshonkov@nokia.com \
--cc=tony@atomide.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).