From mboxrd@z Thu Jan 1 00:00:00 1970 From: Tony Lindgren Subject: Re: 2.6.38 not booting on sbc8100 (aka devkit8000) Date: Thu, 24 Mar 2011 12:00:30 -0700 Message-ID: <20110324190030.GW2811@atomide.com> References: <20110324151844.GT2811@atomide.com> Mime-Version: 1.0 Content-Type: text/plain; charset=us-ascii Return-path: Received: from mho-02-ewr.mailhop.org ([204.13.248.72]:15264 "EHLO mho-02-ewr.mailhop.org" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S933332Ab1CXTAb (ORCPT ); Thu, 24 Mar 2011 15:00:31 -0400 Content-Disposition: inline In-Reply-To: Sender: linux-omap-owner@vger.kernel.org List-Id: linux-omap@vger.kernel.org To: Belisko Marek Cc: linux-omap@vger.kernel.org * Belisko Marek [110324 08:18]: > On Thu, Mar 24, 2011 at 4:18 PM, Tony Lindgren wrote: > > > * Belisko Marek [110324 02:50]: > > > Hi, > > > > > > Try to run 2.6.38 on my sbc8100 > > > (use mach-type for devkit8000 because boards are similar) board but > > > when u-boot load it to ram I see just: > > > ## Booting kernel from Legacy Image at 80300000 ... > > > Image Name: Linux-2.6.38-06570-g79c21b4 > > > Image Type: ARM Linux Kernel Image (uncompressed) > > > Data Size: 2967164 Bytes = 2.8 MB > > > Load Address: 80008000 > > > Entry Point: 80008000 > > > Verifying Checksum ... OK > > > Loading Kernel Image ... OK > > > OK > > > Starting kernel ... > > > > > > I have changed bootargs to: bootargs=console=ttyO2,115200n8 doesn't > > > help. Any ideas what could be checked? > > > > Can you enable DEBUG_LL and EARLY_PRINTK in your .config > > and add earlyprintk to your cmdline? Then you should see > > what goes wrong. > > > Forgot to mention. I already test this options but result is same like I > report in > first email. Maybe add some printk statements to start_kernel function in init/main.c and see if you get any output? Tony