Re: [PATCH] OMAP4: GPIO: Fix missing interrupts during device wakeup due to IOPAD.

[Grant Likely <grant.likely@secretlab.ca>]

On Wed, Jun 15, 2011 at 01:40:45PM -0700, Ambresh K wrote:
> From: Ambresh K <ambresh@ti.com>
> 
> If gpio pins from bank[2-5] are marked as wakeup enable and if the wake is
> through gpio IO pad wakeup, then that wakeup gpio interrupt is lost.
> 
> In the current implementation, GPIO driver stores the context of DATAIN of
> all the gpio in the bank. During GPIO resuming, it checks DATAIN with wakeup
> enabled pins of gpio bank. If there is status change, then manually toggle
> GPIO_LEVELDETECT to generate pseudo interrupt.
> 
> Reported-by: Philippe Mazet <p-mazet@ti.com>
> Tested-by: Philippe Mazet <p-mazet@ti.com>
> Signed-off-by: Ambresh K <ambresh@ti.com>

Applied, thanks.

g.

> ---
>  drivers/gpio/gpio-omap.c |    5 +++--
>  1 files changed, 3 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/gpio/gpio-omap.c b/drivers/gpio/gpio-omap.c
> index 6c51191..eaf3d78 100644
> --- a/drivers/gpio/gpio-omap.c
> +++ b/drivers/gpio/gpio-omap.c
> @@ -477,8 +477,9 @@ static inline void set_24xx_gpio_triggering(struct gpio_bank *bank, int gpio,
>  					+ OMAP24XX_GPIO_CLEARWKUENA);
>  		}
>  	}
> -	/* This part needs to be executed always for OMAP34xx */
> -	if (cpu_is_omap34xx() || (bank->non_wakeup_gpios & gpio_bit)) {
> +	/* This part needs to be executed always for OMAP{34xx, 44xx} */
> +	if (cpu_is_omap34xx() || cpu_is_omap44xx() ||
> +			(bank->non_wakeup_gpios & gpio_bit)) {
>  		/*
>  		 * Log the edge gpio and manually trigger the IRQ
>  		 * after resume if the input level changes
> -- 
> 1.7.0.4
>