Re: help: BeagleBoard xM RevC ethernet port

[Tony Lindgren <tony@atomide.com>]

* Peter Ujfalusi <peter.ujfalusi@ti.com> [120305 01:21]:
> On 02/28/2012 04:04 PM, Govindraj wrote:
> > The issue seems to a mux conflict issue, uart2_rx mux is been taken
> > by uart init and gpio_147 needed for usb phy init is not in mux mode4
> > as set by bootloader.
> > 
> > On beagle I see no other uarts being used other than uart3 as console_uart.
> > So I think it should be okay to init only uart3 from beagle board data.
> > Here is the patch [1] to do the same. (Tested on Beagle Xm Rev.C)
> > 
> > (Any other approach is welcome)
> 
> Thank you, I have working ethernet port finally!!!
> 
> > From f1b43f983a2926c637e6bc6ab5d1e5044339ffd3 Mon Sep 17 00:00:00 2001
> > From: "Govindraj.R" <govindraj.raja@ti.com>
> > Date: Tue, 28 Feb 2012 19:16:33 +0530
> > Subject: [PATCH] omap3_beagle: Init only uart3 used for console
> > 
> > On beagle some of uart mux lines are used for other
> > purpose so init only uart3.
> > 
> > Uart2 rx line clashes with gpio_147 used for usb ehci
> > phy reset.
> 
> Tested-by: Peter Ujfalusi <peter.ujfalusi@ti.com>

Thanks applying into board branch.

Regards,

Tony