Re: [PATCH] arm/dts: am335x-evmsk enable display and lcd panel support

[Darren Etheridge <detheridge@ti.com>]

Tomi Valkeinen <tomi.valkeinen@ti.com> wrote on Fri [2014-May-09 14:29:02 +0300]:
> On 06/05/14 19:10, Tony Lindgren wrote:
> > * Darren Etheridge <detheridge@ti.com> [140422 13:39]:
> >> Add the necessary nodes to enable the LCD controller and the
> >> LCD panel that is attached to the Texas Instruments AM335x
> >> EVMSK platform.  Also setup the necessary pin mux within the
> >> DT file to drive the LCD connector and add the correct
> >> pinmux settings for the lcd pins to be configured to when
> >> the SoC goes into sleep state for the minimum power
> >> consumption.
> >>
> >> For the sleep mode LCD pin settings, MUX_MODE7 is chosen as
> >> this corresponds to switching the pins into input GPIO's with
> >> an internal pulldown.  Which has been determined to offer the
> >> lowest power solution vs leaving the pins configured in LCD
> >> mode.
> > 
> > Probably best that Tomi queues all the panel .dts changes into
> > a separate immutable branch that I can merge too.
> 
> This is not for OMAP DSS, but for the LCDC used in beaglebone, so there
> are no dependencies to any of my work.
> 

Benoit had always queued these LCDC dts patches in the past.  This is
exactly the same as what had been done for AM335x-EVM and
AM335x-BeagleBone both of which are already in the mainline kernel.  I
had just missed the EVMSK previously.

Darren