Re: [PATCH v3 00/10] ARM: dts: TI: Add CAN support

[Tony Lindgren <tony@atomide.com>]

* Roger Quadros <rogerq@ti.com> [141105 03:08]:
> On 11/04/2014 05:55 PM, Tony Lindgren wrote:
> > * Roger Quadros <rogerq@ti.com> [141104 02:50]:
> >> Hi Tony,
> >>
> >> These patches add CAN support for am33xx, am43xx and dra7 platforms.
> >> They must go in together with CAN driver RAMINIT Syscon support [1].
> > 
> > Can you make this series not depend on [1] for most part without
> > breaking existing functionality?
> 
> I just checked that we haven't enabled DCAN on any of the boards
> so we don't risk breaking anything even if these 2 series don't go in
> together. 

OK 
 
> > Then we can do a single follow-up patch to enable things after [1]
> > has been merged.
> > 
> > That would remove a dependency between driver changes and .dts changes.
> 
> Apart from patches 1, 3 and 8, that add the control module nodes the rest
> pretty much depend on the driver DT binding changes.
> 
> I can send them separately if needed.

Well sounds like I can already apply the .dts changes without
affecting anything until the driver changes are merged.

Let me know if that's the case and I'll apply these assuming
the binding is OK and not going to change.

Regards,

Tony