From mboxrd@z Thu Jan 1 00:00:00 1970 From: Vignesh R Subject: [PATCH 1/2] serial: 8250: Don't service RX FIFO if interrupts are disabled Date: Thu, 8 Feb 2018 18:25:41 +0530 Message-ID: <20180208125542.15649-2-vigneshr@ti.com> References: <20180208125542.15649-1-vigneshr@ti.com> Mime-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: <20180208125542.15649-1-vigneshr@ti.com> List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Sender: "linux-arm-kernel" Errors-To: linux-arm-kernel-bounces+linux-arm-kernel=m.gmane.org@lists.infradead.org To: Greg Kroah-Hartman Cc: Vignesh R , linux-kernel@vger.kernel.org, Andy Shevchenko , linux-serial@vger.kernel.org, Jiri Slaby , linux-omap@vger.kernel.org, linux-arm-kernel@lists.infradead.org List-Id: linux-omap@vger.kernel.org Currently, data in RX FIFO is read based on UART_LSR register state even if RDI and RLSI interrupts are disabled in UART_IER register. This is because when IRQ handler is called due to TX FIFO empty event, RX FIFO is serviced based on UART_LSR register status instead of UART_IIR status. This defeats the purpose of disabling UART RX FIFO interrupts during throttling(see, omap_8250_throttle()) as IRQ handler continues to drain UART RX FIFO resulting in overflow of buffer at tty layer. Fix this by making sure that driver drains UART RX FIFO only when UART_IIR_RDI is set along with UART_LSR_BI or UART_LSR_DR bits. Signed-off-by: Vignesh R --- drivers/tty/serial/8250/8250_port.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/tty/serial/8250/8250_port.c b/drivers/tty/serial/8250/8250_port.c index 1328c7e70108..ffbb955d1c06 100644 --- a/drivers/tty/serial/8250/8250_port.c +++ b/drivers/tty/serial/8250/8250_port.c @@ -1854,7 +1854,8 @@ int serial8250_handle_irq(struct uart_port *port, unsigned int iir) status = serial_port_in(port, UART_LSR); - if (status & (UART_LSR_DR | UART_LSR_BI)) { + if (status & (UART_LSR_DR | UART_LSR_BI) && + iir & UART_IIR_RDI) { if (!up->dma || handle_rx_dma(up, iir)) status = serial8250_rx_chars(up, status); } -- 2.16.1