RE: Can't Boot - OSK Frame Buffer Support in Kernel 2.6.18-omap1

Sideleau, Scott R
2006-10-06T19:05:37Z

Hello,

I was finally able to get a successful compile of the 2.6.18-omap1 kernel
with the help of Dirk Behme's config file (thanks again, Dirk). Now, though,
the OSK is unable to boot the new kernel, but instead just hangs. From my
console (as it has been running for the last half-hour)...

=====
U-Boot 1.1.4 (Aug 29 2006 - 17:05:48)

CPU: OMAP162123 at 96.0 MHz (DPLL1=96.0 MHz)
Board: OSK5912
DRAM: 32 MB
Flash: 32 MB
In: serial
Out: serial
Err: serial
Hit any key to stop autoboot: 0
## Booting image at 00100000 ...
Image Name: OE
Image Type: ARM Linux Kernel Image (gzip compressed)
Data Size: 1065210 Bytes = 1 MB
Load Address: 10c08000
Entry Point: 10c08000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK

Starting kernel ...
=====

This kernel build includes the two pushes earlier today by Tony Lindgren.

Any ideas? Any and all help/direction is appreciated.
______________________________________________
Scott R. Sideleau
ECE '07, Worcester Polytechnic Institute
@ MQP Ireland A'06, University of Limerick
+353 61-307310 / srs@wpi.edu