From mboxrd@z Thu Jan 1 00:00:00 1970 From: Nishanth Menon Subject: Re: 2430 linux does not boot in nand Date: Thu, 18 Jan 2007 21:29:45 -0600 Message-ID: <45B03B29.2000702@gmail.com> References: <8bf247760701180640g1886b5edu4cadbeb2a4a2f7c2@mail.gmail.com> Mime-Version: 1.0 Content-Type: text/plain; charset=ISO-8859-1 Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: <8bf247760701180640g1886b5edu4cadbeb2a4a2f7c2@mail.gmail.com> List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Sender: linux-omap-open-source-bounces@linux.omap.com Errors-To: linux-omap-open-source-bounces@linux.omap.com To: Ram Cc: linux-omap-open-source@linux.omap.com List-Id: linux-omap@vger.kernel.org Ram stated on 1/18/2007 8:40 AM: > Hi, > Im using Linux 2.6.14-omap-2430ONLY linux which i downloaded for > linux.omap.com, i have also tried linux-2.6.16omap2430.tgz also. > > Im using a TI 2430 SDP board. > which version? V4.0 or above? > I dont understand why the same kernel with the same bootargs boots > in NOR, but not in NAND. > u have other variables such as a bootloader... > All i get is -- > > OMAP243X SDP # bootm > ## Booting image at 80000000 ... > Image Name: Linux Kernel Image > Image Type: ARM Linux Kernel Image (gzip compressed) > Data Size: 1404634 Bytes = 1.3 MB > Load Address: 80c08000 > Entry Point: 80c08000 > Verifying Checksum ... OK > Uncompressing Kernel Image ... OK > ok so u booted just fine.. u reached the uboot prompt, which is good.. > Starting kernel ... > > Uncompressing > Linux.............................................................................................. > > done, booting the kernel. Now, u need to go back and check ur bootargs. in general that is the culprit.. or u got some bad uboot/x-loader in ur board that did not some clock setting proper or got some dip switch messed up .. am just guessing here.. > > Should i need to enable a few options in make menuconfig for nand > booting? none that i have heard of :) Regards, NM