From: Kevin Hilman <khilman@mvista.com>
To: David Brownell <david-b@pacbell.net>
Cc: linux-omap-open-source@linux.omap.com
Subject: Re: MUSB: unreliable OTG detection in host mode
Date: Fri, 31 Aug 2007 21:55:28 -0700 [thread overview]
Message-ID: <46D8F0C0.7060608@mvista.com> (raw)
In-Reply-To: <20070901021439.D617B235164@adsl-69-226-248-13.dsl.pltn13.pacbell.net>
[-- Attachment #1: Type: text/plain, Size: 1059 bytes --]
David Brownell wrote:
>>> Unreliable in what way(s)?
>> Meaning it sometimes detects connected devices and sometimes not.
>> Sometimes a reboot and another try helps. But with recent git it seems
>> to never detect devices.
>
> What do you mean "detect" though? Does it not see anything
> hooked up to the root hub? Or once it sees something, is there
> some difficulty talking to it? The specifics will say just where
> the problem lies...
Well it depends...
First, for comparison sake, attached is the output from when the driver
is built in host-mode (host.txt) The rest of the test are done with no
changes in cables. devices connected etc...
When I switch to building the driver in OTG mode, either the devices are
detected the same as in host.txt (after the additional 'modprobe
g_zero'), or not even the root hub is detected (see otg1.txt). And
sometimes only the root hub is detected (otg2.txt)
The working OTG case is much more rare than the non-working ones, but I
haven't done enough tests to have a good feel for how often etc.
Kevin
[-- Attachment #2: host.txt --]
[-- Type: text/plain, Size: 2184 bytes --]
# uname -a
Linux omap2430sdp-v4 2.6.23-rc4-omap1-arm-omap2430-default-g8a52303e-dirty #13 PREEMPT Fri Aug 31 21:33:42 PDT 2007 armv6l GNU/Linux
# modprobe musb_hdrc
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
musb_hdrc: version 6.0, musb-dma, host, debug=0
musb_hdrc: ConfigData=0x55 (UTMI-16, dyn FIFOs, bulk split (X), HB-ISO Rx (X))
musb_hdrc: MHDRC RTL version 1.400
musb_hdrc: setup fifo_mode 2
musb_hdrc: 7/15 max ep, 2624/16384 memory
musb_hdrc: hw_ep 0shared, max 64
musb_hdrc: hw_ep 1tx, max 512
musb_hdrc: hw_ep 1rx, max 512
musb_hdrc: hw_ep 2tx, max 512
musb_hdrc: hw_ep 2rx, max 512
musb_hdrc: hw_ep 3shared, max 256
musb_hdrc: hw_ep 4shared, max 256
musb_hdrc: USB Host mode controller at c8854000 using DMA, IRQ 92
musb_hdrc musb_hdrc.0: MUSB HDRC host driver
musb_hdrc musb_hdrc.0: new USB bus registered, assigned bus number 1
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
usb 1-1: new high speed USB device using musb_hdrc and address 2
usb 1-1: configuration #1 chosen from 1 choice
hub 1-1:1.0: USB hub found
hub 1-1:1.0: 7 ports detected
usb 1-1.7: new high speed USB device using musb_hdrc and address 3
usb 1-1.7: configuration #1 chosen from 1 choice
SCSI subsystem initialized
Initializing USB Mass Storage driver...
scsi0 : SCSI emulation for USB Mass Storage devices
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usb-storage: device found at 3
usb-storage: waiting for device to settle before scanning
scsi 0:0:0:0: Direct-Access Flash Drive AL_USB20 1.00 PQ: 0 ANSI: 2
usb-storage: device scan complete
sd 0:0:0:0: [sda] 1018624 512-byte hardware sectors (522 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 03 00 00 00
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] 1018624 512-byte hardware sectors (522 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 03 00 00 00
sd 0:0:0:0: [sda] Assuming drive cache: write through
sda: sda1
sd 0:0:0:0: [sda] Attached SCSI removable disk
[-- Attachment #3: otg1.txt --]
[-- Type: text/plain, Size: 870 bytes --]
# uname -a
Linux omap2430sdp-v4 2.6.23-rc4-omap1-arm-omap2430-default-g8a52303e-dirty #12 PREEMPT Fri Aug 31 17:11:46 PDT 2007 armv6l GNU/Linux
# modprobe musb_hdrc
musb_hdrc: version 6.0, musb-dma, peripheral, debug=0
musb_hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, bulk combine (X), bulk split (X), HB-ISO Rx (X), HB-ISO Tx (X), SoftConn)
musb_hdrc: MHDRC RTL version 1.400
musb_hdrc: setup fifo_mode 2
musb_hdrc: 7/15 max ep, 2624/16384 memory
musb_hdrc: hw_ep 0shared, max 64
musb_hdrc: hw_ep 1tx, max 512
musb_hdrc: hw_ep 1rx, max 512
musb_hdrc: hw_ep 2tx, max 512
musb_hdrc: hw_ep 2rx, max 512
musb_hdrc: hw_ep 3shared, max 256
musb_hdrc: hw_ep 4shared, max 256
musb_hdrc: USB Peripheral mode controller at c8854000 using DMA, IRQ 92
# modprobe g_zero
zero gadget: Gadget Zero, version: St Patrick's Day 2004
zero gadget: using musb_hdrc, OUT ep1out IN ep1in
#
[-- Attachment #4: otg2.txt --]
[-- Type: text/plain, Size: 1987 bytes --]
# modprobe musb_hdrc
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
musb_hdrc: version 6.0, musb-dma, otg (peripheral+host), debug=0
musb_hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, bulk combine (X), bulk split (X))
musb_hdrc: MHDRC RTL version 1.400
musb_hdrc: setup fifo_mode 2
musb_hdrc: 7/15 max ep, 2624/16384 memory
musb_hdrc: hw_ep 0shared, max 64
musb_hdrc: hw_ep 1tx, max 512
musb_hdrc: hw_ep 1rx, max 512
musb_hdrc: hw_ep 2tx, max 512
musb_hdrc: hw_ep 2rx, max 512
musb_hdrc: hw_ep 3shared, max 256
musb_hdrc: hw_ep 4shared, max 256
musb_hdrc: USB OTG mode controller at c8854000 using DMA, IRQ 92
# modprobe g_zero
zero gadget: Gadget Zero, version: St Patrick's Day 2004
zero gadget: using musb_hdrc, OUT ep1out IN ep1in
musb_hdrc musb_hdrc.0: MUSB HDRC host driver
musb_hdrc musb_hdrc.0: new USB bus registered, assigned bus number 1
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
#
[-- Attachment #5: Type: text/plain, Size: 0 bytes --]
prev parent reply other threads:[~2007-09-01 4:55 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2007-09-01 0:05 MUSB: unreliable OTG detection in host mode Kevin Hilman
2007-09-01 0:20 ` David Brownell
2007-09-01 0:29 ` Kevin Hilman
2007-09-01 2:14 ` David Brownell
2007-09-01 4:55 ` Kevin Hilman [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=46D8F0C0.7060608@mvista.com \
--to=khilman@mvista.com \
--cc=david-b@pacbell.net \
--cc=linux-omap-open-source@linux.omap.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox