public inbox for linux-omap@vger.kernel.org
 help / color / mirror / Atom feed
From: David Vrabel <david.vrabel@csr.com>
To: Mike Rapoport <mike@compulab.co.il>
Cc: linux-mmc@vger.kernel.org, linux-omap@vger.kernel.org, madhu.cr@ti.com
Subject: Re: [PATCH 0/3] mmc: omap_hsmmc: support SDIO cards
Date: Thu, 11 Feb 2010 11:10:23 +0000	[thread overview]
Message-ID: <4B73E59F.3020400@csr.com> (raw)
In-Reply-To: <4B73BFD3.8090106@compulab.co.il>

Mike Rapoport wrote:
> Hi David,
> 
> David Vrabel wrote:
>> These patches add support for SDIO cards to the omap_hsmmc driver.  Less
>> restrictions on the sizes of transfers, power management changes to 
>> prevent SDIO cards from being turned off and losing all state, and card
>> interrupts.
>>
>> I've been unable to test these exact patches as I only have an N900 for 
>> testing and the N900 support in mainline is incomplete.
> 
> I've tried your patches on CM-T35 that has 8686 SDIO and the result was
> absence of MMC/SDIO devices at all :( Morover, kmmcd hangs:
> 
> [  399.427764] INFO: task kmmcd:149 blocked for more than 120 seconds.
> [...]
> [  399.485290] [<c01e6264>] (mmc_wait_for_cmd+0x64/0x74) from
> [<c01e86b0>] (mmc_go_idle+0x60/0xac)

I suspect interrupts aren't enabled correctly as this command does not
complete.  Try reverting this hunk.

@@ -426,12 +431,6 @@ omap_hsmmc_start_command(struct omap_hsmmc_host
*host, struct mmc_command *cmd,
                mmc_hostname(host->mmc), cmd->opcode, cmd->arg);
        host->cmd = cmd;

-       /*
-        * Clear status bits and enable interrupts
-        */
-       OMAP_HSMMC_WRITE(host->base, STAT, STAT_CLEAR);
-       OMAP_HSMMC_WRITE(host->base, ISE, INT_EN_MASK);
-
        if (host->use_dma)
                OMAP_HSMMC_WRITE(host->base, IE,
                                 INT_EN_MASK & ~(BRR_ENABLE | BWR_ENABLE));

David
-- 
David Vrabel, Senior Software Engineer, Drivers
CSR, Churchill House, Cambridge Business Park,  Tel: +44 (0)1223 692562
Cowley Road, Cambridge, CB4 0WZ                 http://www.csr.com/


Member of the CSR plc group of companies. CSR plc registered in England and Wales, registered number 4187346, registered office Churchill House, Cambridge Business Park, Cowley Road, Cambridge, CB4 0WZ, United Kingdom

  reply	other threads:[~2010-02-11 11:10 UTC|newest]

Thread overview: 38+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2010-02-10 11:51 [PATCH 0/3] mmc: omap_hsmmc: support SDIO cards David Vrabel
2010-02-10 11:51 ` [PATCH 1/3] mmc: omap_hsmmc: use packet sync'd DMA David Vrabel
2010-02-17 17:21   ` Madhusudhan
2010-02-17 17:47     ` David Vrabel
2010-02-10 11:51 ` [PATCH 2/3] mmc: omap_hsmmc: don't turn SDIO cards off when idle David Vrabel
2010-02-10 11:52 ` [PATCH 3/3] mmc: omap_hsmmc: enable SDIO card interrupts David Vrabel
2010-02-17 18:09   ` David Vrabel
2010-02-17 21:34     ` Cousson, Benoit
2010-02-17 18:45   ` Madhusudhan
2010-02-17 19:39     ` David Vrabel
2010-02-17 20:49       ` Paul Walmsley
2010-02-18 13:20         ` David Vrabel
2010-02-18 17:43           ` Paul Walmsley
2010-02-18 18:39             ` Madhusudhan
2010-02-18 19:27               ` Nicolas Pitre
2010-02-18 20:20                 ` Madhusudhan
2010-02-18 20:21               ` Paul Walmsley
2010-02-18 22:16                 ` Steve Sakoman
2010-02-18 23:45                   ` Nicolas Pitre
2010-03-02 22:08                   ` Madhusudhan
2010-03-02 23:29                     ` Steve Sakoman
2010-02-19 21:47                 ` Madhusudhan
2010-02-18  0:26       ` Madhusudhan
2010-02-18 12:15         ` David Vrabel
2010-02-18 17:03           ` Madhusudhan
2010-02-19 21:05   ` Madhusudhan
2010-02-20  1:37     ` Madhusudhan
2010-02-22 14:28       ` David Vrabel
2010-02-11  8:29 ` [PATCH 0/3] mmc: omap_hsmmc: support SDIO cards Mike Rapoport
2010-02-11 11:10   ` David Vrabel [this message]
2010-02-11 11:42     ` Mike Rapoport
2010-02-11 12:12       ` David Vrabel
2010-02-11 12:31         ` Mike Rapoport
2010-02-18  6:57           ` Mike Rapoport
2010-02-18 16:53             ` Madhusudhan
2010-02-21  6:33               ` Mike Rapoport
2010-02-18  7:02     ` Mike Rapoport
2010-02-18 18:06       ` David Vrabel

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=4B73E59F.3020400@csr.com \
    --to=david.vrabel@csr.com \
    --cc=linux-mmc@vger.kernel.org \
    --cc=linux-omap@vger.kernel.org \
    --cc=madhu.cr@ti.com \
    --cc=mike@compulab.co.il \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox