Re: [PATCH 1/2] USB: musb: add two states to handle vbus error

[wanghui <Hui.Wang@windriver.com>]

On omap platforms, when configuring the kernel, if we choose the musb 
work as host or OTG mode and we plug
a mini-A cable into the socket, after the kernel boot up in host mode or 
insmod gadget driver in OTG mode,
the state of musb's xceiv is A_IDLE or B_IDLE correspondingly because id 
change can't trigger ISR. Under this
condition, if we hotplug a usb device(without self-powered) at the other 
side of the cable, the musb will suffer a vbus error,
This patch can handle this vbus error.

Wang Hui wrote:
> When the MUSB is configured as host mode or OTG mode, the xceiv->state
> will be set to OTG_STATE_A_IDLE or OTG_STATE_B_IDLE unconditionally
> during init process. These init states can change to other
> states When the MUSB module detects id pin change, devices connect or
> disconnect.
> But on some platforms(omap2, omap3), the id pin change
> can't raise IRQ request to the MUSB module, so on these platforms,
> the init xceiv->state will be A_IDLE or B_IDLE. Under this condition,
> when we want the MUSB to act as a host and hotplug a usb device in
> mini-B side of the cable, the MUSB will have a possibility to suffer
> power underrun under A_IDLE or B_IDLE state, So here adding these
> two states under which we can handle VBUSERROR IRQ.
>
> Signed-off-by: Wang Hui <Hui.Wang@windriver.com>
> ---
>  drivers/usb/musb/musb_core.c |    2 ++
>  1 files changed, 2 insertions(+), 0 deletions(-)
>
> diff --git a/drivers/usb/musb/musb_core.c b/drivers/usb/musb/musb_core.c
> index b4bbf8f..655413c 100644
> --- a/drivers/usb/musb/musb_core.c
> +++ b/drivers/usb/musb/musb_core.c
> @@ -516,6 +516,8 @@ static irqreturn_t musb_stage0_irq(struct musb *musb, u8 int_usb,
>  			 * another reset is due (at least for high speed,
>  			 * to redo the chirp etc), it might work OK...
>  			 */
> +		case OTG_STATE_A_IDLE:
> +		case OTG_STATE_B_IDLE:
>  		case OTG_STATE_A_WAIT_BCON:
>  		case OTG_STATE_A_WAIT_VRISE:
>  			if (musb->vbuserr_retry) {
>