From mboxrd@z Thu Jan 1 00:00:00 1970 From: Jarkko Nikula Subject: Re: [regression] Re: [PATCH 3/7] mfd: twl4030-irq: drop the kthread Date: Wed, 07 Dec 2011 15:59:47 +0200 Message-ID: <4EDF7153.7090306@bitmer.com> References: <1309427470-605-1-git-send-email-balbi@ti.com> <1309427470-605-4-git-send-email-balbi@ti.com> <20111207065106.GE32368@legolas.emea.dhcp.ti.com> <20111207133937.GX32368@legolas.emea.dhcp.ti.com> Mime-Version: 1.0 Content-Type: text/plain; charset=ISO-8859-1; format=flowed Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: <20111207133937.GX32368@legolas.emea.dhcp.ti.com> Sender: linux-kernel-owner@vger.kernel.org To: balbi@ti.com Cc: Felipe Contreras , Linux OMAP Mailing List , Linux Kernel Mailing List , Samuel Ortiz , Tony Lindgren , Thomas Gleixner List-Id: linux-omap@vger.kernel.org On 12/07/2011 03:39 PM, Felipe Balbi wrote: >> I'll try to flash a system to NAND, since I can't seem to just get the >> MMC to work when the cover is open and the device is connected to the >> jig to see if I can see something from serial console. >> >> You don't have any idea about what to try? > > you could cut the back cover so that it just fits the device on the jig > (I did that to an old cover), then it works just fine :-) > You could also go without breaking the back cover by putting a magnet on top the hal sensor (like tape a piece from a fridge magnet). See here the place: http://talk.maemo.org/showthread.php?p=1008775 Another option is to to set .gpio_cd = -EINVAL for external mmc in arch/arm/mach-omap2/board-rx51-peripherals.c. -- Jarkko